Справочник Пользователя для LG MODEL STRIKER S160

3.  Next, install baffle bricks #21-24 by sliding the back of

each brick over the center tube and support until the front
of the brick clears the front tube and support. Then lift
the front of the brick above the front support and tube
and slide it forward as far as it can go (very important),
it will hit the front of the stainless support when it is fully
forward. The rear of the bricks sit on top of bricks #19-20
(Figures 7 and 8).

4.  Carefully  slip  the  ceramic  blanket  up  over  the  front  of

the front stainless support and bricks #21-24. Grasp the
edge of the blanket and slide it back until the front of the
blanket is flush to the front of bricks #21-24 (Figure 7).
Shake the blanket gently from side to side to get it to lay
flat. Be sure the ceramic blanket is directly on top of the
baffle bricks and that it does not hang out past the front
of the baffle as shown in Figure 7, also see note on Page
11.