Справочник Пользователя для Insignia HD16

10

To install the camera assembly into the HD16 base:

1.

Remove one of the three thumb nuts from the camera chassis (see 

Loosen the other two thumb nuts.

2.

Slide the gimbal ring under the two loosened thumb nuts.

3.

Adjust the camera position. See “Adjust the Camera” on page 10.

4.

Replace the thumb nut you previously removed in 

5.

Tighten all three thumb nuts to secure the camera assembly.

Make sure that the camera DIP switches are on the top of the lens mount 
when the HD16 is mounted on the wall or ceiling.

To adjust the HD16 Camera:

1.

Apply 11-16 VDC or 24 VAC power to the camera and monitor the video 
signal.

2.

Loosen as many screws and thumb nuts that lock the gimbal assembly in 
place as necessary to adjust the camera position (see 

).

3.

Adjust the camera carrier to the desired view by moving the gimbal in the V 
groove (see 

).

Loosen thumb 
nuts (x2)

Remove thumb nut

Gimbal chassis

Gimbal ring