Справочник Пользователя для Alpine PMD-B200P
PMD-B200P Version 2.0 Owner’s Manual
78
11 In Case of Difficulty
If you encounter a problem, please review the items in the following checklist. This guide will help you
isolate the problem if the unit is at fault. Otherwise make sure the rest of your system is properly
connected, batteries are completely charged and contact your authorised ALPINE dealer.
isolate the problem if the unit is at fault. Otherwise make sure the rest of your system is properly
connected, batteries are completely charged and contact your authorised ALPINE dealer.
Unable to play Music from SD card
Not all SD cards are compatible with Blackbird.
Unable to use Phone feature
Some Bluetooth-enabled phones may not be compatible and some features may not be available
even after synchronising and pairing.
even after synchronising and pairing.
The vehicle’s position is erroneous
Reset the unit and drive the vehicle in an area of good GPS reception to allow the unit to recalibrate
itself. Move to a location where strong GPS reception is possible.
itself. Move to a location where strong GPS reception is possible.
No operation
Moisture condensation
➔
Allow enough time for the condensation to evaporate (about 1 hour).
Ambient temperature
➔
Lower the temperature in the vehicle to below 45°C over 45°C (113°F)
(113°F) by driving with the windows open or air con ditioner on.
Blown fuse
➔
Replace with a fuse of the prescribed rating (2A glass-type fuse located in the head of
the cigarette lighter adapter).
Unit does not work after removing from cradle or dock
Make sure the battery is fully charged. Unit does not charge in cradle or dock while the ignition is
turned off.
turned off.
Low RDS-TMC signal
In order to improve the RDS Traffic signal strength, you may need to separate the RDS antenna away
from the power cord on the Cradle. Carefully follow these instructions:
from the power cord on the Cradle. Carefully follow these instructions:
➔
Power off the unit and unplug the Cigarette Lighter Charger.
➔
Identify the RDS antenna. It is the thin, black, insulated wire that runs the full length of the
thicker power cord.
thicker power cord.
➔
Carefully cut the thin RDS antenna at the point where it enters the connector that attaches it to
the Cigarette Lighter Charger. Be careful ONLY to cut the antenna, not the larger main
power cable.
the Cigarette Lighter Charger. Be careful ONLY to cut the antenna, not the larger main
power cable.
➔
Slowly peel the antenna away from the power cord to leave about 130 cm of the antenna
separated and hanging free.
separated and hanging free.
➔
Place antenna on the vehicle dashboard or for best results, mount the antenna to the
windshield.
windshield.