Руководство По Установке для Smart Choice ELDRY3W

2

For  your  safety  the  information  in  this  manual  must  be  followed  to  minimize  the  risk  of  fire  or  explosion  or  to  prevent 

property damage, personal injury or loss of life. Do not store or use gasoline or other flammable vapors and liquids in the 

vicinity of this or any other appliance.

To avoid back or other injury, have more than one person

move or lift the appliance.

Read all of the following instructions before installing and using this appliance:

• Destroy the carton and plastic bags after the dryer is unpacked. Children might use them for play. Cartons covered with 

rugs, bedspreads, or plastic sheets can become airtight chambers causing suffocation. Place all materials in a garbage 

container or make materials inaccessible to children.

• Clothes dryer installation and service must be performed by a qualified installer, service agency or the gas supplier.
• Install the clothes dryer according to the manufacturer’s instructions and local codes.
• The electrical service to the dryer must conform with local codes and ordinances and the latest edition of the National 

Electrical Code, ANSI/NFPA 70, or in Canada, the Canadian electrical code C22.1 part 1.

• The dryer is designed under ANSI Z 21.5.1  or ANSI/UL 2158 - CAN/CSA C22.2 No. 112 (latest editions) for HOME USE 

only. This dryer is not recommended for commercial applications such as restaurants, beauty salons, etc.

• Do not install a clothes dryer with flexible plastic or flexible foil venting material. Flexible venting materials are known to 

collapse, be easily crushed and trap lint. These conditions will obstruct clothes dryer air flow and increase the risk of fire.

• Do not stack a dryer on top of washer already installed on pedestal. Do not stack dryer on top of another dryer. Do not 

stack washer on top of dryer. Do not stack washer on top of another washer. Do not stack dryer on top of washer without 

use of manufacturer approved and correctly installed stacking kit appropriate for your model.

• The instructions in this manual and all other literature included with this dryer are not meant to cover every possible 

condition and situation that may occur. Good safe practice and caution MUST be applied when installing, operating and 

maintaining any appliance. 

Tools and materials needed for installation:

•

•

Phillips and straight

bit screwdrivers

•

Carpenter’s level

• External vent hood

•

•

•

4-inch (102 mm), rigid metal or

semi-rigid metal exhaust duct work

3-wire or 4-wire 240 volt cord kit

(electric dryer)

4 in. (102 mm) clamp

Metal foil tape (not duct tape)