Инструкции По Установке для Whirlpool WGE555S0B
9
4-wire connection: Power Supply Cord
Use this method for:
■
New branch-circuit installations (1996 NEC)
■
Mobile homes
■
Recreational vehicles
■
In an area where local codes prohibit grounding through the
neutral
neutral
1. Part of metal ground strap must be cut out and removed.
2. Use Phillips screwdriver to remove the ground-link screw from
the back of the range. Save the ground-link screw and the end
of the ground link under the screw.
of the ground link under the screw.
3. Feed the power supply cord through the strain relief in the cord/
conduit plate on bottom of range. Allow enough slack to easily
attach the wiring to the terminal block.
attach the wiring to the terminal block.
4. Use Phillips screwdriver to connect the green ground wire from
the power supply cord to the range with the ground-link screw.
The ground wire must be attached first.
The ground wire must be attached first.
5. Use
³⁄₈" nut driver to connect the neutral (white) wire to the
center terminal block post with one of the 10–32 hex nuts.
6. Connect line 1 (black) and line 2 (red) wires to the outer terminal
block posts with 10-32 hex nuts.
7. Securely tighten hex nuts.
NOTE: For power supply cord replacement, only use a power
cord rated at 250 volts minimum, 40 amps or 50 amps that is
marked for use with nominal 1
cord rated at 250 volts minimum, 40 amps or 50 amps that is
marked for use with nominal 1
³⁄₈" (3.5 cm) diameter connection
opening, with ring terminals and marked for use with ranges.
8. Replace terminal block access cover.
3-wire connection: Power Supply Cord
Use this method only if local codes permit connecting chassis
ground conductor to neutral wire of power supply cord.
1. Feed the power supply cord through the strain relief in the cord/
ground conductor to neutral wire of power supply cord.
1. Feed the power supply cord through the strain relief in the cord/
conduit plate on bottom of range. Allow enough slack to easily
attach the wiring to the terminal block.
attach the wiring to the terminal block.
A. Metal ground strap
B. Discard
B. Discard
C. Ground-link screw
A. Terminal block
B. Ground-link screw
B. Ground-link screw
C. Cord/conduit plate
D. Power supply cord wires
D. Power supply cord wires
A
B
C
A
B
C
D
A. 10–32 hex nut
B. Ground-link screw
B. Ground-link screw
C. Line 1 (black)
D. Green ground wire
E. Neutral (center) wire
F. Line 2 (red)
A. Terminal block
B. Ground-link screw
B. Ground-link screw
C. Cord/conduit plate
D. Power supply cord wires
D. Power supply cord wires
A
B
C
F
D
E
A
C
B
D