Инструкции По Установке для Speed Queen ATGE9AGP113TW01
Installation
Before You Start
Tools
For most installations, the basic tools you will need are:
SWD1021N_SVG
11
10
9
8
4
3
2
1
6
7
5
1. Wrench
2. 1/4 inch Driver
3. Screwdriver
4. Level
5. Wood Block
6. Pliers
7. 5/16 Inch Socket Wrench
8. Gloves
9. Teflon Tape (Gas Models)
10. Duct Tape
11. Safety Glasses
2. 1/4 inch Driver
3. Screwdriver
4. Level
5. Wood Block
6. Pliers
7. 5/16 Inch Socket Wrench
8. Gloves
9. Teflon Tape (Gas Models)
10. Duct Tape
11. Safety Glasses
Figure 1
NOTE: If the unit is delivered on a cold day (below
freezing), or is stored in an unheated room or area dur-
ing the cold months, do not attempt to operate it until
the unit has had a chance to warm up.
freezing), or is stored in an unheated room or area dur-
ing the cold months, do not attempt to operate it until
the unit has had a chance to warm up.
NOTE: Some moisture in the wash drum is normal. Wa-
ter is used during testing at the manufacturer.
ter is used during testing at the manufacturer.
NOTE: This appliance is suitable for use in countries
having a warm, damp climate.
having a warm, damp climate.
WARNING
Any disassembly requiring the use of tools must be
performed by a suitably qualified service person.
performed by a suitably qualified service person.
W299
Parts Included
An accessories bag has been shipped inside your unit. It includes:
• Installation Instructions
• Two User's Guides (one for washer and one for dryer)
• Warranty Bond
• Three screws (electric dryers only)
• Two fill hoses with washers and filter screens
• Four rubber feet
• Beaded strap
• Two User's Guides (one for washer and one for dryer)
• Warranty Bond
• Three screws (electric dryers only)
• Two fill hoses with washers and filter screens
• Four rubber feet
• Beaded strap
Removing Dryer
Use the following steps if the installation requires removal of the
dryer. Two people are required to perform this task.
1. Remove dryer front access panel.
2. Remove two screws holding control panel to control cabinet.
3. Remove two 7/16 inch screws and washers attaching dryer to
dryer. Two people are required to perform this task.
1. Remove dryer front access panel.
2. Remove two screws holding control panel to control cabinet.
3. Remove two 7/16 inch screws and washers attaching dryer to
washer.
4. Tip dryer back and disconnect dryer control wire harness
from main dryer wire harness.
5. Slide dryer forward until rear leveling legs slide into notches
in the control cabinet.
6. Lift dryer and place it on a level surface.
Reassembling Dryer
1. Lift dryer and place it on top of washer so dryer leveling legs
sit in notches in control cabinet.
2. Slide dryer backward until mounting holes in base line up
with holes in front of security cabinet.
3. Reconnect dryer wire harness. If needed, refer to unit’s wiring
diagram.
4. Tip dryer and replace two 7/16 inch screws and washers hold-
ing dryer to washer.
5. Reattach the control panel to the control cabinet using two
screws.
6. Replace dryer’s front access panel.
Order of Installation Steps
Installation
Part No. 804671R2
©
Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT
9