Инструкции По Установке для BlueStar BSP366B
10
BACKGUARD
All ranges require a backguard. Most models have the option of using: grate height trim; island trim; 6”
inch standard; 17” inch hi-back; 24” inch high shelf. Heritage Classic models require a 24” inch high
shelf for all installations.
shelf for all installations.
If you are using an island trim or grate height, a six inch clearance between the back of the range and a
combustible surface is required. If an island trim is to be used without this six inch clearance, the back
wall must be constructed using non-combustible and heat resistant materials that extend below the top
surface of the range a minimum of six inches.
wall must be constructed using non-combustible and heat resistant materials that extend below the top
surface of the range a minimum of six inches.
All backguards follow the same basic installation. Remove rear grates, slide backguard over rear of unit,
align holes, use hardware supplied to fasten backguard to unit. A minimum of six sheet metal screws
(more depending on width) are to be installed, three on each end and more along the bottom edge.
(more depending on width) are to be installed, three on each end and more along the bottom edge.
Remove the two rear ring grate/top grates from the cooktop surface. Sheet metal screws must be installed
- down - into the cooktop support. Screws are installed on each end ring grate/top grate position.
Replace the removed grates.
Replace the removed grates.
ANTI-TIP BRACKET
UNDER NO CICUMSTANCES SHOULD YOU STAND ON THE DOOR OF YOUR RANGE OR USE IT AS A
STEP. YOUR ANTI-TIP BRACKET SHOULD BE INSTALLED PRIOR TO INSTALLATION OF YOUR
BLUESTAR RANGE.
STEP. YOUR ANTI-TIP BRACKET SHOULD BE INSTALLED PRIOR TO INSTALLATION OF YOUR
BLUESTAR RANGE.
THE ANTI-TIP BRACKET MUST BE ANCHORED SECURELY TO THE SUB-FLOOR. CONTACT A
QUALIFIED FLOOR COVERING INSTALLER FOR THE BEST PROCEDURE OF DRILLING MOUNTING
HOLES THROUGH YOUR TYPE OF FLOOR COVERING.
QUALIFIED FLOOR COVERING INSTALLER FOR THE BEST PROCEDURE OF DRILLING MOUNTING
HOLES THROUGH YOUR TYPE OF FLOOR COVERING.
BRACKET SHOULD BE INSTALLED 1 ½” FROM THE LEFT SIDE OF THE UNIT AND FLUSH AGAINST
THE WALL WITH FASTENER HOLES CLOSEST TO THE WALL.