Инструкции По Установке для Maytag MLE24PDAWW

1.   Remove red cap from gas pipe.
2.   Connect gas supply to dryer. Use pipe-joint compound 

resistant to the action of L.P. gas for gas connections. If 

flexible metal tubing is used, be certain there are no kinks.

 

 If necessary for service, open the toe panel. Use a putty knife 

to press on the toe panel locks located at the upper corners 

of the toe panel. Pull downward on the toe panel to open.  

Toe panel is hinged at the bottom.

3.   Open the shut-off valve in the gas supply line. 
4.   Test all connections by brushing on an approved 

noncorrosive leak-detection solution. Bubbles will show a 

leak. Correct any leaks found.

1.   Using a 4" (102 mm) clamp, connect vent to exhaust outlet  

on rear of dryer. If connecting to existing vent, make sure the 

vent is clean. The dryer vent must fit over the dryer exhaust 

outlet and inside the exhaust hood. Make sure the vent is 

secured to exhaust hood with a 4" (102 mm) clamp.

2.   Using two or more people, move dryer to desired installation 

location. Do not crush or kink vent. Make sure dryer is level.

3.  Check that there are no kinks in the flexible gas line.

1.   With dryer in final position, place level on top of the dryer, first 

side to side; then front to back. If the dryer is not level, adjust 

the legs of the dryer up or down until the dryer is level.

2.   Using a TORX

®†

 T20 security driver, open the control panel 

and rest it on the bottom edge of the opening. 

3.   For added security between the upper dryer and the collar, 

insert the cotter pin through the connecting bolt.

4.   Close the control panel.

5.   Plug into a grounding 3-prong outlet.
6.   Check dryer operation. 
 

 Select a full heat cycle, let the dryer run for at least five 

minutes. Dryer will stop when time is used up.

 

 NOTE: DRYER DOOR MUST BE CLOSED FOR DRYER 

TO OPERATE. When door is opened, dryer stops, but time 

continues to count down. To restart dryer, close door and 

reselect cycle.

7.   If the burner does not ignite and you can feel no heat inside 

the dryer, shut off dryer for five minutes. Check that all supply 

valve controls are in “ON” position and that the electrical cord 

is plugged in. Repeat five-minute test.

■  This dryer is manufactured ready to install with a 3-wire 

electrical supply connection. The neutral ground conductor is 

permanently connected to the neutral conductor (white wire) 

within the dryer. If the dryer is installed with a 4-wire electrical 

supply connection, the neutral ground conductor must be 

removed from the external ground connector (green screw), 

and secured under the neutral terminal (center or white wire) 

of the terminal block. When the neutral ground conductor is 

secured under the neutral terminal (center or white wire) of the 

terminal block, the dryer cabinet is isolated from the neutral 

conductor.

† ® TORX is a registered trademark of Saturn Fasteners, Inc.