Инструкции По Установке для Maytag MLE24PDAWW

Shape 

ends of 

wires into  

a hook.

Strip 3

1

⁄

2

" (89 mm) of outer 

covering from end of cable. 

Strip insulation back 1"  

(25 mm). If using 3 wire 

cable with ground wire,  

cut green or bare wire  

even with outer covering.

Three wire with ground wire: green or bare 

wire cut short. Wire is not used. Dryer is 

grounded through neutral conductor.

To  

disconnect 

box

1” (25 mm) 

of wires 

stripped of 

insulation

3

1

⁄

2

" (89 mm)

5.   Loosen or remove the center terminal 

block screw.

6.   Place the hooked end of the neutral wire 

(white or center) of the direct wire cable 
under the center screw of the terminal 
block (hook facing right). Squeeze 
hooked end together. Tighten screw.

7.   Place the hooked ends of the other 

direct wire cable wires under the outer 
terminal block screws (hook facing right). 
Squeeze hooked ends together. Tighten 
screws.

8.   Insert tab of the terminal block cover into 

slot of the dryer rear panel. Secure cover 
with hold-down screw.

5.   Remove the center terminal block screw.
6.   Remove the appliance neutral ground wire 

from the external ground conductor screw. 
Connect the appliance neutral ground wire 
and the neutral wire (white or center) of the 
direct wire cable under the center terminal 
block screw. Tighten screw.

7.   Connect the other wires to outer terminal 

block screws. Tighten screws.

8.   Insert tab of the terminal block cover into 

slot of the dryer rear panel. Secure cover 
with hold-down screw.

9.   After reattaching the terminal cover, 

connect a separate copper ground wire 
from the external ground connector screw 
to an adequate ground.

If codes permit and a separate ground wire 
is used, it is recommended that a qualified 
electrician determine that the ground path  
is adequate.