Инструкции По Установке для Maytag MLE24PDAWW

1.   Using a 4" (102 mm) clamp, connect vent to exhaust outlet  

in dryer. If connecting to existing vent, make sure the vent is 
clean. The dryer vent must fit over the dryer exhaust outlet 
and inside the exhaust hood. Make sure the vent is secured  
to exhaust hood with a 4" (102 mm) clamp.

2.  

Using two or more people, move dryer to desired installation 
location. Do not crush or kink vent. Make sure dryer is level.

1.   With dryer in final position, place level on top of the dryer, first 

side to side; then front to back. If the dryer is not level, adjust 
the legs of the dryer up or down until the dryer is level.

2.   Using a TORX

®†

 T20 security driver, open the control panel 

and rest it on the bottom edge of the opening. 

3.   For added security between the upper dryer and the collar, 

insert the cotter pin through the connecting bolt.

4.   Close the control panel.
5.   Plug in dryer or reconnect power.
6   Check dryer operation. 
 

 Select a full heat cycle, let the dryer run for at least five 
minutes. Dryer will stop when time is used up.

 

 NOTE: Dryer door must be closed for dryer to operate. When 

door is opened, dryer stops, but time continues to count 
down. To restart dryer, close door and reselect cycle.

7.   Now start the dryer and allow it to complete a full heat cycle 

to make sure it is working properly.

You can change your door swing from a right-side opening to a 

left-side opening, if desired. 

1.   Open dryer door. Remove bottom screws from cabinet side  

of hinges (A). Loosen (do not remove) top screws from 
cabinet side of hinges. 

2.   Lift door until top screws in cabinet are in large part of  

hinge slot. Pull door forward off screws. Remove top  
screws from cabinet.

3.   Remove screws attaching hinges to door.
4.   Remove screws from all sides of door (5 screws). Grasp sides 

of outer door and gently lift to separate it from inner door (do 
not pry apart). Do not pull on door seal or plastic door catch.

5.   Reattach outer door panel to 

inner door panel so handle  
is on the side where hinges  
were just removed. 

6.   Attach door hinges to dryer door so that the larger hole is  

at the bottom of the hinge and the hinge pin is toward the 
door front.

7.   Remove the 4 screws that attach 2 plugs (B) on the handle 

side. Attach plugs to opposite side using the same 4 screws.

8.   Insert screws into bottom holes on left 

side of cabinet. Tighten screws halfway. 
Position door so large end of door hinge 
slot is over screws. Slide door up so 
screws are in bottom of slots. Tighten 
screws. Insert and tighten top  
screws in hinges.

9.   Close door and check that door strike aligns with door  

catch (C).

† ® TORX is a registered trademark of Saturn Fasteners, Inc.