Инструкции По Установке для Maytag MLE24PDAWW

n

 Clean lint screen after each cycle.

n

  Removing accumulated lint:

 From inside the dryer cabinet:

      Lint should be removed every 2 years or more often, 

depending on dryer usage. Cleaning should be done  
by a qualified person.

 From the exhaust vent:

      Lint should be removed every 2 years, or more often, 

depending on dryer usage.

n

  Keep area around dryer clear and free from combustible 

materials, gasoline, and other flammable vapors and liquids.

n

  Keep dryer area clear and free from items that would obstruct 

the flow of combustion and ventilation air.

n

 Electrical supply is connected.

n

  Circuit breaker is not tripped or house fuse is not blown.

n

 Door is closed.

n

  Controls are set in a running or “ON” position.

n

 Cycle has been selected.

n

  For gas dryers, check that gas supply shut-off valves are set  

in open position.

If you need assistance:
The Commercial Laundry Support Center will answer any 
questions about operating or maintaining your dryer not covered 
in the Installation Instructions. Just dial 

(1-800-662-3587) — the call is toll free.
When you call, you will need the dryer model number and serial 
number. Both numbers can be found on the serial-rating plate 
located in the dryer door well.

ESD problems are present everywhere. ESD may damage  

or weaken the electronic control assembly. The new control 

assembly may appear to work well after repair is finished,  

but failure may occur at a later date due to ESD stress.

n

   Use an anti-static wrist strap. Connect wrist strap to green 

ground connection point or unpainted metal in the appliance

-OR-

Touch your finger repeatedly to a green ground connection 

point or unpainted metal in the appliance.

n

   Before removing the part from its package, touch the anti-

static bag to a green ground connection point or unpainted 

metal in the appliance.

n

   Avoid touching electronic parts or terminal contacts; handle 

electronic control assembly by edges only.

n

    When repackaging failed electronic control assembly in  

anti-static bag, observe above instructions.

BASIC OPERATION OF COMMERCIAL DRYER
n

   For additional information, see www.MaytagCommercialLaundry.com

Blank display
This condition indicates the appliance is inoperative. Enter  

set-up mode to view diagnostic code.

“

This condition indicates the appliance cannot be operated. 

Coins dropped or debit inputs during this condition will be 

stored in escrow but cannot be used until normal operation  

is restored by opening and closing the door. If a door switch 

fails, it must be replaced before normal operation can be 

restored.

Cold Start (initial first use)
Appliance is programmed at the factory as follows:

n

   5 minutes dry time/quarter (coin 1).

n

 $1.50 dry price (fixed cycle with top off – PD Models).

n

   $0.00 dry price (fixed cycle – PR Models).

Warm Start (after power failure)
A few seconds after power is restored, if a cycle was in 

progress at the time of the power failure, “RESELECT CYCLE” 

will flash in the display. This is to indicate the need for a fabric 

setting key pad to be pressed to restart dryer.