Инструкции По Установке для Bosch HCG56651UC

8

9

WARNING

RISK OF ELECTRIC SHOCK
Parts inside the appliance can have sharp edges. 

The connection cable can be damaged. Do not 

bend or pinch connection cables during installation.

Before connecting the appliance, check the household 

installation. Ensure sufficient fuse protection of the 

household installation. The voltage and frequency of the 

appliance must match the electrical installation (see 

rating plate).
The appliance complies with protection class 1 and must 

only be operated in conjunction with a protective 

conductor terminal.
An all-pole isolating switch with at least a 3 mm contact 

gap must be fitted in the installation. This must remain 

accessible after installation.
Only a qualified electrician who takes the appropriate 

regulations into account may lay or replace the 

connecting cable.
Follow all valid standards and laws.

Ensure that the electrical connection meets the 

requirements of the latest version of all applicable 

standards and laws in the appropriate country, especially 

the following standards: National Electrical Code, ANSI/

NFPA 70*, or CSA Standards C22.1-94, Canadian 

Electrical Code, Part 1 and C22.2 No.0-M91**. 
Have a qualified electrical technician check the 

grounding of the appliance.
Do not ground with a gas line.
No fuse protection in the neutral or grounding circuit.
Keep the installation instructions. Only connect the 

appliance with a copper conductor. If possible, connect 

the appliance to a metal cable guide directly to the fuse 

box.
Ensure that the wire diameter meets the requirements of 

the latest version of all applicable standards and laws in 

the appropriate country, especially the following 

standards: National Electrical Code, ANSI/NFPA 70*, or 

CSA Standards C22.1-94, Canadian Electrical Code, Part 

1 and C22.2 No.0-M91**.
Put a protecting hose that is listed in the U.L. or C.S.A. on 

both ends of the connecting cable, that is, on the 

appliance and on the fuse box.
For copies of the standards listed, contact:
* National Fire Protection Association Batterymarch Park 

Quincy, Massachusetts 02269
** CSA International 8501 East Pleasant Valley Road 

Cleveland, Ohio 44131-5575

Measuring tape
Pencil
Phillips screwdriver (Posidrive) #2
Drill with the following bits: 5/16" (7.9 mm) and 3/8" 

(9.5 mm)
Spirit-level
Aluminum tape (DO NOT use insulating tape)
Exhaust channel (configuration depends on the 

installation situation)
Additional sheet metal screws (if necessary for 

installation of the exhaust air duct)
Saw

Extractor hood with fan, back-pressure flap
Lamp, already installed
Metal grease filter
Flue duct
Drill template
1x angle bracket for the flue duct 
Instruction manual and installation instructions
6x screws, 5x45 mm
8x screws, 4x8 mm
2 washers
2x hollow wall plugs, 8x40 mm
4x hollow wall plugs, 10x50 mm
Torx adapter, 10 & 20