Инструкции По Установке для Gaggenau VG491210CA
16
7
Fit the cooktop and screw it down evenly. Fit
burner parts and pot supports, paying attention to
correct positioning.
burner parts and pot supports, paying attention to
correct positioning.
8
Set the pressure regulator to the correct pressure
(see “Connect gas supply”).
(see “Connect gas supply”).
Replacing the main nozzles Wok burner
1
Detach securing clips from the burner pipes.
Remove burner pipes. Loosen screw on air-
regulating tube. Remove nozzle fitting.
Remove burner pipes. Loosen screw on air-
regulating tube. Remove nozzle fitting.
2
Losen the burner holder.
3
Remove nozzle and O-ring for inner circular
burner by hand. Unscrew nozzle for outer circular
burner (SW10).
burner by hand. Unscrew nozzle for outer circular
burner (SW10).
4
Check that O-ring is correctly positioned in new
main nozzle for inner circular burner. Push nozzle
onto burner pipe. Screw new main nozzle for
outer circular burner all the way into nozzle fitting.
main nozzle for inner circular burner. Push nozzle
onto burner pipe. Screw new main nozzle for
outer circular burner all the way into nozzle fitting.
5
Put on nozzle fitting and burner pipes. Put on
securing clips.
securing clips.
6
Set air-regulating sleeve to correct dimension
after loosening the screw (see nozzle table).
Tighten screw again.
after loosening the screw (see nozzle table).
Tighten screw again.
7
Fit the cooktop and screw it down evenly. Fit
burner parts and pot supports, paying attention to
correct positioning.
burner parts and pot supports, paying attention to
correct positioning.
8
Set the pressure regulator to the correct pressure
(see section “Connect Gas Supply”).
(see section “Connect Gas Supply”).
Checking functions after the conversion:
The flames are adjusted correctly if no yellow tips are
visible. They must not go out when switching over
swiftly from the high to the low setting.
visible. They must not go out when switching over
swiftly from the high to the low setting.
Note: Stick the adhesive label included with the
nozzle set over the rating plate of the appliance to
document the changeover to a different gas type.
nozzle set over the rating plate of the appliance to
document the changeover to a different gas type.
Z
Z
/