Техническое Описание для Frigidaire FFFS5115PA
Specifications
subject to change.
Specifications
subject to change.
USA
•
10200 David Taylor Drive
•
Charlotte, NC 28262
•
1-800-FRIGIDAIRE
•
frigidaire.com
CANADA
•
5855 Terry Fox Way
•
Mississauga, ON L5V 3E4
•
1-800-265-8352
•
frigidaire.ca
FFFS5115P
07/13
© 2013 Electrolux Home Products, Inc.
Front Load Washers
FFFS5115P A/W
3.9 Cu. Ft. D.O.E.
Front Load Washer Specifications
•
•
Product Shipping Weight (approx.) – 222 Lbs.
•
An electrical supply with grounded three-prong receptacle is
required. The power supply circuit must be installed in accordance
with current edition of National Electrical Code (ANSI/NFPA 70) and
local codes & ordinances. (Do not use same circuit as dryer.)
•
Voltage Rating – 120V / 60 Hz / 15 Amps
•
Amps @ 120 Volts = 10 Amps
•
Equipped with 120V 3-wire power supply cord, approx. 60" long.
•
Always consult local and national electric & plumbing codes.
•
To maximize detergent effectiveness, ambient temperature should
never be below 60° F.
•
Can be installed alone, with or without optional 15" Pedestal Drawer, or
stacked below matching Frigidaire® Dryer, which requires installation of
optional Dryer Stacking Kit. (For installation details, refer to instructions
included with optional pedestal or stacking kit or on web.)
•
Can be built in with matching Frigidaire® Dryer in under-counter,
recessed or closet installation. (Refer to Built-In Installations on this
page for cutout dimensions. For additional installation details, refer to
Product Installation Guide on web.)
•
Closet installation requires vented door with 2 unobstructed louvered
openings, minimum 60 sq. in. each, located 3" from top and bottom
of door. Full-length 120 sq. in. opening also acceptable. Allow
additional 1" clearance between fronts of units and closed door.
•
Do NOT install in area exposed to dripping water or outdoor
weather conditions, or where gasoline or other flammables, including
automobiles, are kept or stored.
•
Floor MUST be solid with 1" maximum slope. To minimize vibration or
movement, reinforcement of floor may be necessary. Do NOT install
on carpeted surface.
•
Leveling legs supplied to level washer properly and reduce excessive
noise and vibration.
•
H/C water faucets MUST be installed within 42" of washer’s water
inlet and MUST be 3/4" to connect to 43" inlet hoses.
•
Water pressure MUST be between 30 and 120 psi with NOT more
than 10 psi pressure difference between hot and cold.
•
Drain required with standpipe diameter of 1-1/4" min. and height of
24" min. / 96" max. above floor, capable of eliminating 17 gallons per
minute. Attached 52" drain hose can reach 74"-high standpipe. For
higher standpipe, optional Drain Hose Extension Kit available.
Note: For planning purposes only. Refer to Product Installation Guide
on the web at frigidaire.com for detailed instructions.
Optional Accessories
•
•
Dryer Stacking Kit – (PN # STACKIT4X).
•
15" Classic Silver Pedestal Drawer – (PN # CFPWD15A).
•
15" Classic White Pedestal Drawer – (PN # CFPWD15W).
•
Mobile Home Installation Kit – (PN # 137067200).
•
Drain Hose Extension Kit – (PN # 137098000).
•
6' Stainless Steel Washer Fill Hose (2 pack) - (PN # 5305516562).
•
4' Rubber Washer Fill Hose (2 pack) - (PN # 5308815006).
Front Load Laundry - Washers
Frigidaire Affinity (All N & P Models)