Инструкции По Установке для Monogram ZIBI240PII

Скачать
Страница из 12
THE INSTALLATION SPACE
The cutout depth should be 24
The cutout dimensions shown allow for a full door 
swing and access to the pull-out racks when installed 
in standard 24
″ deep cabinets.
• All models may be used freestanding.
• If installing a stainless steel model between frameless
cabinets, a 1/2
″ wide filler strip or side panel may be
needed on the hinge side. The filler strip will act as 
a spacer between the case and adjacent cabinet door
swing. The width of the opening must include the filler
panels. 
Note: The stainless steel door should be flush with the
surrounding cabinets.
Additional Specifications
• A 120 volt 60Hz., 15 or 20 amp power supply is
required. An individual properly grounded branch circuit
or circuit breaker is recommended. Install a properly
grounded 3-prong electrical receptacle recessed into
the back wall as shown. Electrical must be located on
rear wall as shown. NOTE: GFCI (ground fault circuit
interrupter) is not recommended.
PRODUCT CLEARANCES
The Fresh-Food Refrigerator or Bar Refrigerator with
Icemaker is factory set for a 110° door swing.
When installed in a corner:
• Allow 14
″ minimum clearance on the hinge side
for a full 110° door swing.
• Allow 4
″ min. clearance on the hinge side for 
the 90° door swing and to allow racks to slide out.
NOTE: Clearances are based on the recommended 
2-1/4
″ handle standoff depth.
NOTE: Right hand models illustrated. Allow the same
clearances on the opposite side for left hand fresh food
models ZIFI240 and ZIFS240 only. Models ZIBI240 and
ZIBS240 are not available with left hand door swing.
• Test the door swing. Carefully open and close the door.
The door should not rub or catch on adjacent cabinetry. 
Choose the location:
• These products may be closed in on the top and 
three sides as long as the front is unobstructed for 
air circulation and proper access to the door.
• Do not install these products where the temperature
will go below 55°F (13°C) or above 90°F (32°C).
• These products are not designed to be stacked one
over the other.
4
SIDE-BY-SIDE INSTALLATIONS
For a complete refreshment center, install a Fresh-Food Refrigerator
beside a Double Drawer Refrigerator, Beverage Center or Wine Chiller/
Wine Reserve. Or, install a Refrigerator with Icemaker beside 
a Wine Chiller/Wine Reserve.
• A side-by-side installation requires at least a 47-1/2
″ wide opening. 
No trim kits required.
• Products must operate from separate, properly grounded receptacles.
14" Minimum to Wall 
110
°
110
° Door 
Swing
21-5/8"
23-5/8"
4" Minimum to Wall
90
°
90
° Door 
Swing
34-1/2"-35"
24" 
47-1/2" Min.
1-1/2" 
9"
 
10-1/2"
 
9"
 
10-1/2" 
14"
 
15" 
Locate
Outlet
Locate  
Outlet 
34-1/2"-35"
24"
23-3/4" Min.
1-1/2" 
9"  
Max.
8-1/2" 
23-3/4"
 
34-1/4"
23-3/4"
26" 
Including  
Handle
 
9" Max.
  
10-1/2"
 
1-1/2"
to 34-3/4"
NOTE:
Handle and
handle standoff
depth is 2-1/4
″.
For models ZIFS240 and ZIBS240 with Stainless Steel Doors and Handles
NOTE:
Water line location
for ZIBI240 or
ZIBS240 model only
Design Guide