Инструкции По Установке для Monogram ZIBI240PII
ZTBSS1 Monogram Tubular Handle Kit
•
BEFORE YOU BEGIN:
Read these instructions completely and carefully.
•
IMPORTANT:
Save these instructions for local inspector’s use.
•
IMPORTANT:
Observe all governing codes and ordinances.
• Note to Installer – Be sure to leave these instructions
with the Consumer.
• Note to Consumer – Keep these instructions with your
Owner’s Manual for future reference. This kit provides a
stainless steel tubular handle to coordinate with other
Monogram appliances.
stainless steel tubular handle to coordinate with other
Monogram appliances.
• The tubular handle must be installed onto the 3/4
″
thick portion of the custom wood panel before
the panel is secured to the door.
the panel is secured to the door.
TOOLS AND MATERIALS REQUIRED:
• Gloves to protect against sharp edges
• #2 Phillips screwdriver
• Drill and 1/4
• #2 Phillips screwdriver
• Drill and 1/4
″ bit and 1/2″ spade bit
• Safety glasses
• Center punch
• Pencil
• Center punch
• Pencil
THIS KIT INCLUDES
• Tubular handle
• 2 Mounting screws
• 2 Handle standoffs
• 2 Set screws for standoffs
• 2 Nuts
• 2 Washers
• Allen Wrench
• 2 Mounting screws
• 2 Handle standoffs
• 2 Set screws for standoffs
• 2 Nuts
• 2 Washers
• Allen Wrench
INSTALL THE TUBULAR HANDLE
• Use the handle as a template to locate and mark the
exact position of the screw holes. Be careful to avoid
interference with custom panel mounting screws.
interference with custom panel mounting screws.
• Draw a pencil line, top to bottom and 7/8
″ from the
outside edge.
• Hold the tubular handle against the appearance side,
centered on the marked line.
• Mark the screw hole locations at the center of the
handle attachment posts.
• Center punch the marked hole locations. Drill 1/4
″ pilot
holes from the appearance side through the entire panel
thickness.
thickness.
• Use a 1/2
″ spade bit to drill 1/4″ to 5/16″ deep into
the back side of the panel. Insert washer (spacer) into
the hole.
the hole.
• Install screw through the handle standoff and into
the pilot hole.
• Fasten nut onto the screw until the standoff is tight
against the panel. The screw hole on the standoff
should be pointing down toward the floor.
should be pointing down toward the floor.
• Place handle attachment posts inside the standoffs.
• Use the Allen wrench to install the set screws. Tighten
handle to standoffs.
30”
24-7/32”
7/8”
Handle
Standoff
Standoff
Handle
Attachment
Post
Attachment
Post
Tubular
Handle
Handle
Screw
Set
Screw
Screw
Washer
Nut
Custom
Framed
Panel
Framed
Panel
9