Использование И Уход для Amana AFI2539ERM

1. Position the handle so that the large holes in the mounting 

clips are down and align the holes with the door studs.

2. Rotate the handle so that the mounting clips are flat against 

the door and slide the handle down to engage. See Handle 
graphic.

IMPORTANT: Remove food and any adjustable door or utility bins 
from doors.

1. Unplug refrigerator or disconnect power.

2. Keep the refrigerator doors closed until you are ready to lift 

them free from the cabinet.

NOTE: Provide additional support for the refrigerator door 
while the hinges are being removed. Do not depend on the 
door gasket magnets to hold the door in place while you are 
working

3. Starting with the right-hand side door, remove the parts for 

the top hinge as shown in Top Hinge graphic. Lift the 
refrigerator door from the bottom hinge pin.

4. Remove top hinge cover from left side refrigerator door. 

5. Disconnect the wiring plug located on top of the hinge by 

wedging a flat-blade screwdriver or your fingernail between 
the two sections. See Connections graphic.

6. Disconnect the water line by pulling back on the locking collar 

while pulling the water line out of the water line connector. 
See Connections graphic. 

7. Remove the parts for the top hinge as shown in Top Hinge 

graphic. Lift the left-hand side door from the bottom hinge 
pin.

8. Remove the base grille. Grasp the grille firmly and pull it 

toward you.

9. Using a 

³⁄₈" hex wrench, remove the leveling leg brackets from 

the bottom of the cabinet. Keep screws for later use. 

1. Assemble the parts for the top hinge as shown in Top Hinge 

graphic. Do not tighten the screws completely.

2. Replace the parts for the bottom hinge as shown in Bottom 

Hinge graphic. Tighten screws. Replace the refrigerator door.

NOTE: Provide additional support for the refrigerator door 
while the hinges are being moved. Do not depend on the door 
gasket magnets to hold the door in place while you are 
working.

3. Align the door so that the bottom of the refrigerator door 

aligns evenly with the top of the freezer drawer. Tighten all 
screws.

4. Reconnect the wiring plug on top of the left-hand side 

refrigerator door.

5. Reconnect the water line by pulling back the locking collar 

ring while firmly pushing the water line into the connector. 

6. Check for leaks. Replace the top hinge covers.

IMPORTANT: Two people may be required to remove and replace 
the freezer drawer. Graphics are included later in this section. 

1. Open the freezer drawer to full extension.

2. Loosen the four screws attaching the drawer glides to the 

drawer front. See Drawer Front Removal graphic.

NOTE: Loosen screws three to four turns. Keep the screws in 
the drawer front.

3. Lift drawer front upward and off the screws. See Drawer Front 

Removal graphic. 

1. Slide the drawer glides out of the freezer compartment. Insert 

the screws in the top of the drawer front into the slots in the 
drawer brackets. See Drawer Front Replacement graphic. 

2. Pull the drawer brackets toward you to position the two 

screws in the bottom of the drawer front into the brackets. 
See Drawer Front Replacement graphic.

3. Completely tighten the four screws.

1. Replace the base grille. 

2. Plug into a grounded 3 prong outlet.

3. Return all removable parts to doors and drawer and food to 

refrigerator and freezer.