Инструкции Пользователя для Frigidaire FGGF3058RW

34

Each burner head has a small ignition port (Fig. 1). Should 

you experience ignition problems it may be that this port 

hole is partially blocked with soil. With the burner head in 

place, use a small wire gauge needle or the end of a paper 

clip to clear the ignition port (center burner not shown).

To avoid possible burns DO NOT attempt any of the 

cleaning instructions provided below before turning OFF 

all of the surface burners and allow them to cool.

1.  Turn electrical power off at the main source or unplug 

the range.

2.  While holding the glass shield in place, press wire 

holder to one side to release the glass shield.

3.  Remove glass shield. Replace bulb with a new 40 watt 

appliance bulb.

4.  Replace glass shield over bulb and snap wire holder 

into place.

5.  Turn power back on again at the main source (or plug 

the range back in).

6.  The clock will need to be reset. To reset review 

“Setting the clock” section in this manual.

wire

holder

glass

shield

The interior oven light is 

located at the rear of the 

oven interior back wall 

and is protected with a 

glass shield held by a wire 

holder.

The glass shield should 

always be in place 

to protect and shield 

the oven interior light 

whenever using the oven.

Be sure the range is unplugged and all parts are COOL 

before replacing the oven light. Wear a leather-faced 

glove for protection against possible broken glass.

Using a liner in the 

oven restricts the heat 

and air flow needed to 

obtain the best possible 

cooking results for any 

oven, including the 

warmer drawer (on 

some models).

Do not use oven bottom liners or use aluminum foil to 

cover the oven bottom or any oven racks.

Aluminum foil and oven liners (cont’d)

During self-clean the oven temperature can become hot 

enough to melt aluminum cooking utensils or aluminum 

foil if left in the oven. This could result in damage to the 

oven interior porcelain finish.

For proper gas flow it 

may be necessary to 

clean the burner head 

and slots. To clean, 

remove burner cap 

and use a clean DAMP 

cloth to soak up any 

excessive spills.

Remove any food from 

• The burner heads are secured to the cooktop and 

must be cleaned in place. DO NOT remove from 

cooktop.

• For proper flow of gas and ignition of burners DO 

between the burner slots using a small nonabrasive brush 

like a toothbrush. Afterwards wipe up using a damp cloth. 

For stubborn soils, use a small-gauge wire or needle to 

clean.

After cleaning the burner heads or ignition ports, be sure 

to replace the burner caps properly on the burner 

heads. See section “Checking for proper burner cap 

placement”.