Техническое Руководство для Frigidaire FAHE1011MW
Specifications
subject to change.
Top Load Laundry - Washer
Frigidaire Affinity (M models)
Top Load Washer Specifications
•
Product Shipping Weight (approx.) – 171 Lbs.
•
An electrical supply with grounded three-prong receptacle is
required. The power supply circuit must be installed in accordance
with current edition of National Electrical Code (ANSI/NFPA 70) and
local codes & ordinances. (Do not use same circuit as dryer.)
•
Voltage Rating – 120V / 60 Hz / 15 Amps
•
Amps @ 120 Volts = 4.0 Amps
•
Equipped with 120V 3-wire power supply cord, approx. 60" long.
•
Always consult local and national electric & plumbing codes.
•
To maximize detergent effectiveness, ambient temperature should
never be below 60° F.
•
Washer can be installed in recess or closet requiring 0" minimum
installation clearance around sides and back of unit. To achieve
0" minimum rear clearance when installed with dryer, dryer MUST
be vented straight back. Closet installation requires additional 1"
minimum clearance between front of unit and door. If washer and
dryer are installed in same closet, door MUST be vented with 120 sq.
in. minimum louvered opening, equally divided, located 3" from top
and bottom of door. A louvered door with equivalent air openings
for full-length of door is acceptable. Air openings MUST remain
unobstructed with door installed. (For additional installation details,
refer to Product Installation Guide on web.)
•
Do NOT install in area exposed to dripping water or outdoor weather
conditions; or where gasoline or other flammables, including
automobiles, are kept or stored.
•
Floor MUST be solid with 1" maximum slope. To minimize vibration
or movement, reinforcement of floor may be necessary. Do NOT
install on carpeted surface.
•
Leveling legs supplied to level unit properly and reduce excessive
noise and vibration.
•
H/C water faucets MUST be installed within 42" of washer’s water
inlet and MUST be 3/4" with threading for laundry hose connection
to connect to 48" inlet hoses.
•
Water pressure MUST be between 30 and 120 psi with NOT more
than 10 psi pressure difference between hot and cold.
•
Drain standpipe requires diameter of 1-1/4" min. and height of
33" min. / 96" max. above floor, capable of eliminating 17 gallons
per minute. Attached 52" drain hose can reach 74"-high standpipe.
For higher standpipe, optional Drain Hose Extension Kit available.
•
For manufactured or mobile home installation optional Mobile Home
Installation Kit (PN # 137067200) required. (For specific installation
details, refer to Product Installation Guide on web.)
Note: For planning purposes only. Refer to Product Installation Guide
on the web at frigidaire.com for detailed instructions.
Optional Accessories
•
Mobile Home Installation Kit – (PN # 137067200).
•
Drain Hose Extension Kit – (PN # 137098000).
USA
•
10200 David Taylor Drive
•
Charlotte, NC 28262
•
1-800-FRIGIDAIRE
•
frigidaire.com
CANADA
•
5855 Terry Fox Way
•
Mississauga, ON L5V 3E4
•
1-800-265-8352
•
frigidaire.ca
FAHE1011M 06/12
© 2012 Electrolux Home Products, Inc.
Top Load Washer
FAHE1011M W
3.4 Cu. Ft. D.O.E.