Инструкция С Настройками для Sunpentown WA1350DE
17
Using the Remote Controller
AUTO operation
With the AC unit plugged in:
1. Press the MODE button to select Auto.
2. Press the TEMP button to set desired temperature, between 21
AUTO operation
With the AC unit plugged in:
1. Press the MODE button to select Auto.
2. Press the TEMP button to set desired temperature, between 21
-28°C / 70-84°F. Each press
is an increment of 1°C (2°F).
3. Press the ON/OFF button to start the AC unit.
NOTE:
Under Auto mode, the AC unit automatically chooses the operating mode (COOL, FAN or
DRY), by sensing the difference between the ambient temperature and set temperature on
the remote controller.
DRY), by sensing the difference between the ambient temperature and set temperature on
the remote controller.
In Auto mode, the fan speed is automatically set and cannot be changed. There will be no
indicators shown on the display panel.
indicators shown on the display panel.
If Auto mode is not comfortable for you, switch to COOL mode.
COOL / FAN operation
With the AC unit plugged in:
1. Press the MODE button to select Cool or Fan mode.
2. Press the TEMP button to set desired temperature, between
17-30°C / 62-88°F. Each press
is an increment of 1°C (2°F).
3.
Press the FAN SPEED button to select fan speed.
4. Press the ON/OFF button to start the AC unit.
NOTE:
Under FAN mode, temperature cannot be set and thus, no temperature will be displayed. Only
steps 1,3, and 4 may be performed.
DRY (dehumidifying) operation
With the AC unit plugged in:
Under FAN mode, temperature cannot be set and thus, no temperature will be displayed. Only
steps 1,3, and 4 may be performed.
DRY (dehumidifying) operation
With the AC unit plugged in:
1. Press the MODE button to select DRY mode.
2. Press the TEMP button to set desired temperature, between 21
2. Press the TEMP button to set desired temperature, between 21
-28°C / 70-84°F. Each press
is an increment of 1°C (2°F).
3. Press the ON/OFF button to start the AC unit.
NOTE: Under DRY mode, fan speed is automatically controlled.
TIMER operation
To set Auto-on timer:
TIMER operation
To set Auto-on timer:
1. Press the TIMER ON button and remote will display TIMER ON. The last Auto-on setting and
the signal “h” will also be displayed.
2. Press the TIMER ON button again to set desired Auto-on timer. Keep pressing the button
until the desired time has been reached.
To set Auto-off timer:
1. Press the TIMER OFF button and remote will display TIMER OFF. The last Auto-off setting
and the signal “h” will also be displayed.
2. Press the TIMER OFF button again to set desired Auto-off timer. Keep pressing the button
until the desired time has been reached.
After setting TIMER ON/OFF, there will be a one-half second delay before the remote transmits
the signal to the AC unit. Then after approximated another 2 seconds, the signal “h” will
disappear and the set temperature will re-appear on the LCD display.
NOTE: The setting time is relative time – time set is based on the delay of current time.
the signal to the AC unit. Then after approximated another 2 seconds, the signal “h” will
disappear and the set temperature will re-appear on the LCD display.
NOTE: The setting time is relative time – time set is based on the delay of current time.