Инструкция для Summit SEH36

Screw the chimney mounting parts into Ø 10mm sized wall 
plugs on E,F points which is provided with your product. 

INSTALLING THE RANGE HOOD ON THE 
WALL
A)DRILLING OF HANGING HOLES
 Set the assembly scheme onto place where 
the product will be mounted and open the 
holes on A,B,C,D points with Ø 10mm sized 
drill bit.
Open holes at points E and F with a Ø 10mm 
sized drill bit in order to screw chimney 
assembly parts in place 15mm below ceiling

B)SCREWING OF WALL PLUGS
Screw the Ø 10mm sized wall plugs into A, B, 
C,D holes for hanging screws.
Screw the Ø 10mm sized wall plugs into E, F 
holes for chimney mounting parts. 

C)SCREWING OF HANGING SCREWS
Screw the hanging screws into Ø 10mm sized 
wall plugs in A, B holes.
There must be 5mm distance between screw 
head and wall.

F

E

Ø10

E,F

Ø10

A,B,C,D

B

A

D

C

wood wall

E

F

wood wall

EFFICIENT VENTILATION 
For correct ventilation, windows opening outside must be kept closed.  Doors and 
windows opening to other rooms may be kept open. 

Pay attention when operating the hood simultaneously with devices that 
work  by  burning  the  ambient  air  with  fuel  (such  as  gas  heaters).    The 
burning may be affected because the hood discharges air in the room to 
the outside.  

This advice does not apply to hoods not having an outside exhaust.

Peel off protective films from the stainless steel components after assembly.
PUSH-BUTTON CONTROLS
Your range hood has three levels of ventilation.  According to your needs, you 
can choose a low (|), medium (||) or high (|||) ventilation level by pushing one of 
the first three buttons on the front panel.

The fourth button (Lamp) controls the lighting of the hood.  There are 2 bulbs 
which are turned on and off by pressing the Lamp button.