Справочник Пользователя для Sharp R1880LSRT
C L E A N I N G A N D C A R E
FAN
The fan will automatically start when heat rises from
range surface units or burners and when convection,
high mix, low mix or the broil settings are used. This
protects the microwave oven from excessive tem-
perature rise. The fan will stay on until the temperature
decreases. It cannot be turned off manually during
this time.
For other uses, select either high or low speed.
range surface units or burners and when convection,
high mix, low mix or the broil settings are used. This
protects the microwave oven from excessive tem-
perature rise. The fan will stay on until the temperature
decreases. It cannot be turned off manually during
this time.
For other uses, select either high or low speed.
PRECAUTIONS FOR PROPER USE:
1. DO NOT leave range unattended while using high
1. DO NOT leave range unattended while using high
temperatures. Automatic fan may start and provide
excessive air to the surface units. This may cause
spattering or boilover.
excessive air to the surface units. This may cause
spattering or boilover.
2. Avoid burning food.
3. Keep grease filters clean.
3. Keep grease filters clean.
lIGHT
1. To replace light bulbs, first disconnect power to the
oven at the circuit breaker panel or by unplugging.
2. To release cover remove the screw on the light cover.
(See illustration.)
3. Replace bulbs only with equivalent watt bulbs
available from a Sharp Authorized Servicer or parts
distributor. Bulbs are also available at most hardware
stores or lighting centers. DO NOT USE A BULB
LARGER THAN 30 WATTS.
distributor. Bulbs are also available at most hardware
stores or lighting centers. DO NOT USE A BULB
LARGER THAN 30 WATTS.
4. Close light cover and secure with screw removed in
step 2.
CAUTION: Light cover may become very hot. Do not
touch glass when light is on. Do not use light for long
time use such as a night light.
touch glass when light is on. Do not use light for long
time use such as a night light.
Light cover
Screw
Light bulbs
CHARCOAl FIlTER
Charcoal Filter, Sharp Part Number RK-220 is used for
Non-vented, recirculated installation. The filter should be
changed every 6 to 12 months depending on use.
1. Disconnect power to the oven at the circuit breaker
Non-vented, recirculated installation. The filter should be
changed every 6 to 12 months depending on use.
1. Disconnect power to the oven at the circuit breaker
panel or by unplugging.
2. Remove 3 screws that secure louver.
3. Remove louver by inserting flat edge screwdriver
3. Remove louver by inserting flat edge screwdriver
over each tab pressing the tab down and moving
louver away from unit.
louver away from unit.
4. Pull the louver away from the oven.
5. Remove 2 screws that secure the sensor duct
5. Remove 2 screws that secure the sensor duct
cover.
6. Remove the sensor duct cover.
7. Remove old charcoal filter (if one is installed).
8. Slide new Charcoal Filter into position on the sup-
7. Remove old charcoal filter (if one is installed).
8. Slide new Charcoal Filter into position on the sup-
port tabs.
9. Reattach sensor duct cover and secure with 2
screws.
10. Push louver back into place and gently snap tabs
into place by hand (engaging both the bottom
and top tabs) and replace the 3 screws to secure
louver.
and top tabs) and replace the 3 screws to secure
louver.
Sensor duct cover
Charcoal filter