Инструкции Пользователя для Thermador PRG486GDH
English 2
Safety
IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
Gas and Electrical Requirements and
Grounding Instructions
Grounding Instructions
PLEASE READ CAREFULLY
Gas Type Verification
Verify the type of gas supplied to the location.
Ensure that the appliance is connected to the
type of gas for which it is certified. Models
come from the factory certified for use with
natural gas or with propane (LP) gas. Make
certain your range and gas type are the same.
Refer to the product rating label which can be
located as indicated on page 34.
Ensure that the appliance is connected to the
type of gas for which it is certified. Models
come from the factory certified for use with
natural gas or with propane (LP) gas. Make
certain your range and gas type are the same.
Refer to the product rating label which can be
located as indicated on page 34.
CAUTION:
When connecting the unit to propane gas, make
certain the propane gas tank is equipped with its
own high-pressure regulator in addition to the
pressure regulator supplied with the range. The
maximum gas pressure to this appliance must
not exceed 14.0 inches water column (34.9 mb)
from the propane gas tank to the pressure
regulator.
certain the propane gas tank is equipped with its
own high-pressure regulator in addition to the
pressure regulator supplied with the range. The
maximum gas pressure to this appliance must
not exceed 14.0 inches water column (34.9 mb)
from the propane gas tank to the pressure
regulator.
Important:
All ranges must be installed with a backguard. The 30"
model comes with a Low Back, and the 36” and 48” models
are supplied with a Flush Island Trim. Other available
backguards must be ordered separately and installed at the
back of the range. The three backguard choices include a
Low Back, Pot and Pan Shelf, or Flush Island Trim. Before
using the range, insure that it is equipped with a proper
backguard. DO NOT attempt to use a backguard that is not
designed to fit your particular model range. Refer to the
Installation Instructions accompanying this appliance for
more information.
model comes with a Low Back, and the 36” and 48” models
are supplied with a Flush Island Trim. Other available
backguards must be ordered separately and installed at the
back of the range. The three backguard choices include a
Low Back, Pot and Pan Shelf, or Flush Island Trim. Before
using the range, insure that it is equipped with a proper
backguard. DO NOT attempt to use a backguard that is not
designed to fit your particular model range. Refer to the
Installation Instructions accompanying this appliance for
more information.
30" Gas Models:
120 volts, 60 Hz., 10 Amp electrical circuit required.
36" Gas Models:
120 volts, 60 Hz., 10 Amp electrical circuit required. 36"
gas range with electric griddle - 20 Amp circuit required.
gas range with electric griddle - 20 Amp circuit required.
48" Gas Models with electric griddle:
120 volts, 60 Hz, 20 Amp electric circuit required.
WARNING:
ALWAYS DISCONNECT THE ELECTRICAL
PLUG FROM THE WALL RECEPTACLE
BEFORE SERVICING THIS UNIT
PLUG FROM THE WALL RECEPTACLE
BEFORE SERVICING THIS UNIT
It is recommended that a dedicated circuit servicing this
appliance be provided.
appliance be provided.
The use of gas cooking appliances results in the production
of heat and moisture.
of heat and moisture.
CAUTION:
FOR PERSONAL SAFETY, THIS APPLIANCE
MUST BE CONNECTED TO A PROPERLY
GROUNDED AND POLARIZED ELECTRICAL
POWER SUPPLY.
MUST BE CONNECTED TO A PROPERLY
GROUNDED AND POLARIZED ELECTRICAL
POWER SUPPLY.
WARNING:
To avoid possible burn or fire hazard, a
backguard designed specifically for this range
must be installed whenever the range is used.
backguard designed specifically for this range
must be installed whenever the range is used.
See Installation Instructions for complete electrical
requirements and grounding instructions.
requirements and grounding instructions.
It is the personal responsibility and obligation of you, the
user, to have this appliance connected to the electrical
power supply by a qualified electrician, in accordance with
the National Electrical Code and/or applicable local codes
and ordinances.
user, to have this appliance connected to the electrical
power supply by a qualified electrician, in accordance with
the National Electrical Code and/or applicable local codes
and ordinances.