Инструкции По Установке для Monogram ZDP304NPSS

Locate the 1–1/2” long Grill orifice. 
Select for your gas type. LP

—

.047, NAT

—

.067

A. Remove the grill cover,

grates and grate frame. Lift
the radiant baffle straight
up and off.

B. Remove the 2 hex

head screws from 
the top of the igniter.
• Remove one screw

from each side of
the burner surround.

• Lift out the surround.

C. Carefully push the

igniter aside and
under 
the burner. 
Do not pull or pinch
the wire.
Remove 4 burner
attachment screws,
2 at the front and 2
at the back. Slide the
burner assembly
toward the back and
out of the gas inlet.

D. Use a 1/2" deep well

socket to remove 
and replace the orifice .
Reverse these 
steps to re-assemble
the grill. Be sure to
place the unused 
orifice in the holder 
for possible future use. 

Remove 2

hex head

screws

Burner

Surround

Igniter

Burner

Assembly

IMPORTANT: Find your model number below. Read
each orifice label to identify and install them in the
exact locations shown.

A. Return the unused orifices to the holder. Reattach

the holder and the instruction sheet with screw 
in the original storage location.

B. Replace the burner heads, caps and top grates.

On range models, replace rear vent trim.

Surround

Screws

Front of Range