Инструкции По Установке для Monogram ZDP304NPSS

•The natural gas models are designed to operate

at 5" water column pressure. For proper operation,
the pressure of the natural gas supplied to the
regulator must be between 7" and 13" water
column.

•The LP models are designed to operate at 10"

water column pressure. For proper operation, 
the pressure of the LP gas supplied to 
the regulator must be between 11" 
and 13" water column.

•A 1/2" elbow is provided for connection 

to the range gas inlet, located at the rear 
and near the floor.

•Locate the pipe stub on the back wall or floor 

as illustrated in “Dimensions and Clearances.” 
Use 5-foot maximum length, 5/8" O.D. flexible 
gas supply line (3-foot in Massachusetts).

•Install a manual shut-off valve in the gas line 

(not provided), in an easily accessible location.
Make sure the homeowner knows where 
and how to shut off the gas supply to the range.

If the electrical service provided does not meet 
the above specifications, it is recommended that 
a licensed electrician install an approved outlet.

•Locate the electric supply as illustrated 

in “Dimensions and Clearances.”

The range is equipped for use with an electrical
supply which uses a separate grounding conductor
(4 wire system).

If this range must be connected to an electrical 
system which utilizes a single conductor for ground
and neutral (3 wire system), the grounding jumper
at the terminal block must be connected. 
The grounding jumper is located to the right 
of the terminal block.

See 3-wire power cord installation on the next page.

These ranges must be supplied with 208/240 volt, 
60 Hz., and connected to an individual, properly
grounded branch circuit protected by a circuit
breaker or time delay fuse (50 amp for 48" ranges, 
30 amp for 36" and 30" ranges). The receptacle 
must be a NEMA 14-50R device to accept the 
4-prong plug supplied with the range.

The access plate

is on the back 

of the range.