Инструкции Пользователя для Speed Queen AWNE92SP113TW01

Troubleshooting

Try these troubleshooting tips before making a service call. They
may save you time and money.

Washer Symptom

Possible Cause/Solution

Won't Fill

• Make sure power cord is plugged all the way into the electrical

outlet.

• Make sure hot and cold water faucets are turned on.
• Make sure that the fill hoses are not kinked or twisted.
• Press Start/Pause button to start washer.
• Make sure that the controls are properly set.
• In the Normal Eco cycle, during the rinse portion of the cycle,

the tub won’t fill with water. Instead, there is a spray rinse.

• Make sure that the last spin has been completed.
• Check the laundry room fuse or circuit breaker.
• Clean the screens in the water mixing valve and the filter

screens located at the faucet end of the fill hoses. (Owner is
responsible for service calls regarding cleaning of the screens.)

• Water is being siphoned from the washer during the cycle. Re-

fer to the Installation instructions to make sure that the drain
hose has been properly installed.

Won't Start

• Make sure lid is closed.
• Press Start/Pause button to start washer.
• Make sure power cord is plugged all the way into the electrical

outlet.

• Make sure that the controls are properly set.
• Check the laundry room fuse or circuit breaker.
• The motor overload protector may have stopped the cycle. It

will reset itself and the display will show tp, St. Press the
Start/Pause button to resume cycle.

Won't Agitate

• Make sure lid is closed.
• Press Start/Pause button to start washer.
• Make sure power cord is plugged all the way into the electrical

outlet.

• Check the laundry room fuse or circuit breaker.
• The motor overload protector may have stopped the cycle. It

will reset itself and the display will show tp, St. Press the
Start/Pause button to resume cycle.

• Broken drive belt. Call the service person.

Troubleshooting

Part No. 202956R2