Инструкции По Установке для Dacor RNR30NS
17
Installation Instructions
Re-installing the Oven Door
WARNING
To avoid personal injury or damage to the door from it
falling off its hinges:
• Make sure that the notch on the bottom of each hinge rests
• Make sure that the notch on the bottom of each hinge rests
on top of the lower lip of each hinge receptacle before
attempting to open the oven door.
• Rotate the hinge locks toward the front of the range
immediately after installation of the door.
1. Grasp the oven door on opposite sides and hold it at a 15°
angle from the front of the range. Slide the hinges into the
hinge openings, resting the bottom of the hinge arms on the
hinge receptacles. Continue to hold the door at a 15° angle
with one hand while pushing in on each of the bottom corners
of the door. Push until the notch on the bottom of each hinge
slips over the lower lip of each hinge receptacle.
2. Lower the door to the fully opened position.
3. Rotate the two hinge locks toward the range.
4. Slowly and carefully open and close the door completely to
3. Rotate the two hinge locks toward the range.
4. Slowly and carefully open and close the door completely to
ensure that it is properly installed.
Verifying Proper Operation
1. Remove any packaging from inside the oven.
2. Slide the oven racks onto the supports inside the oven
2. Slide the oven racks onto the supports inside the oven
chamber according to the use and care manual.
3. Prior to operating the range, read the accompanying use and
care manual carefully. Important safety, service and warranty
information are contained within.
4. Turn on power to the range at the circuit breaker panel or
fuse box.
5. Set the clock according to the use and care manual.
6. Press the
6. Press the
BAKE key on the control panel. The default bake
temperature should appear on the display.
7. Press
START. After approximately three (3) minutes, check to
make sure the oven is heating.
8. Press
CANCEL SECURE.
9. Place a pot 1/4 full with water on one of the cooking
elements. Match the size of the pot to the size of the cooking
element.
NOTE: You must use a pot that attracts a magnet
on the pan bottom to test operation.
10. Hold your finger on the
ON/OFF key of the corresponding
control for one second to activate. The power light should
come.
11. Touch the power level up key (►) repeatedly. Verify that the
power level goes up.
12. Touch down (◄) repeatedly. Verify that the power level goes
down.
13. Touch the power level up key (►) repeatedly until the power
boost light comes on.
14. Once the pot begins to heat, verify that the heat indicator light
comes on.
15. Touch
ON/OFF to turn off the element.
16. Repeat steps 9 through 15 for the remaining elements.
continued...
continued...
Cooktop Control
ON/OFF
key
Up key
Power
light
Down
key
Heat
indicator
Power
level
indicators
No pan
detected
light
Power
boost
light