Инструкции По Установке для Dacor RNRP30GSNGH

Installing the Anti-Tip Bracket to the Wall

1.  Determine the suitability of wall mounting the anti-tip bracket. 

To use the wall mount option, the range front panel (excluding 

the bull nose) must not be more than 27 inches (68.6 cm) 

from the wall, and the bracket screws must be able to thread 

into the back wall’s interal base plate (see Inside the Back 

Wall).

2.  The notches on the sides of the bracket indicate the minimum 

required height of the base plate and that any floor covering 

is not too thick for proper screw thread engagement.

The base plate is located on the floor, behind the wall. It will 

anchor the anti-tip bracket (see Inside the Back Wall).
Find the range’s center line and front panel according to 

the diagram below and the final installation cabinet / cutout 

dimensions.
1.  Find and mark the position of the anti-tip bracket, based on 

the diagram below. 

2.  Push the bracket up against the wall and into position.
3.  Determine if the base plate behind the wall (see Inside the 

Back Wall) is tall enough to grab the screws. 

• 

Using a pencil, mark a dot next to the notches on both sides 

of the bracket. Drill just deep enough to see if the bit contacts 

the base plate. 

• 

When the drill bit contacts the base plate, you will know 

screws in the anti-tip bracket will also contact the base plate. 

This setup is successful.

• 

If the drill bit does not contact the base plate, the wall 

mounting method should not be used. The floor mounting 

method is more suitable, or the wall must be modified so that 

the base plate can be accessed or anchors can be used.

CL

CL

Installing the Anti-Tip Bracket to the Wall

Concrete or wood sub-

floor, no floor covering

#8 x 1 *

Concrete or wood sub-

floor, floor covering up to 

1/4” thick

#8 x 1 *

Concrete or wood sub-

floor, floor covering over 

1/4” and up to 1/2” thick

#8 x 1 1/4 *

Wood sub-floor, floor 

covering over 1/2” and up 

to 1 3/16” thick

#12 x 1 3/4 *

Concrete under floor 

covering over 1/2” thick

Must be purchased separately **

Wood sub-floor, floor 

covering over 1 3/16” thick

Must be purchased separately **

* Included with range
** Determine required depth based on information in Step 3 and 

purchase from local hardware store.

Range front panel

Wall

Anti-tip

bracket

Base 

plate

Drywall

Notch

11 7/8”

Installation Instructions