Справочник Пользователя для U-Line BI98

www.U-LineService.com

02/2005

1. Open the water supply valve in the main water source.

2. Plug in the power cord.

3. Gently push the unit into position. Be careful not to 

kink the water supply line or entangle the electrical 
cord. 

4. Re-check the leveling, from front to back and side to 

side. Make any necessary adjustments. The unit’s top 
surface should be approximately 1/8" below the 
countertop.

1. Locate and remove the grille screw from the cabinet, 

using a standard blade screwdriver (or a 1/4" 
nutdriver). See Figure 21.

2. Identify the grille screw hole on the grille itself. It is 

located toward the top of the middle recessed section 
of the grille.

3. Place the two hook-hinges (located on the rear bottom 

side of the grille) onto the front lip of the unit base. 
Swing the grille up into position, aligning the grille 
screw hole on the grille to the grille screw hole on the 
cabinet. See Figure 22.

4. Insert the screw. Do not overtighten.

Water is leaking under the unit.

A water leak under the unit is most likely caused by a bad 
connection in the water supply line. Make sure the water 
line’s brass fitting is screwed tight to its valve and 
threaded correctly. Make sure that plumbers tape was 
NOT used; if it was remove all traces before reinstalling.

Grille Screw

Hook-Hinge

Unit Base

Front Lip

Grille