Краткое Руководство По Установке для Bose® 791

Be sure to cut carefully to make the hole as regular as 
possible. However, when the speaker is in place, the 
frame overlaps the cutting edge by 

5

/

8

 

 

in. (0.6 cm), which 

masks minor cutting inaccuracies.

1. Hold the cutting blade in a vertical position and keep 

it straight as you cut the hole. 

This helps prevent the blade from angling away from 
the outlined circle. 

2. Insert the tip of your saw into the pilot hole and cut 

most of the way around the circular outline.

3. Place one hand under the circle to brace it and 

complete cutting the hole. 

4. Remove the cutout section.

5. Clear away any torn or rough material from around 

the hole. 
Such material can interfere with a tight seal between 
the speaker and the ceiling.

When your speaker cable is within reach of the hole you 
have cut, follow the procedure below:

1. Push any insulation away from inside the speaker 

hole.

Be sure that all blown insulation is at least 4 to 6 in. 
(10 to 15 cm) from the edges of the hole.

2. Locate and pull out at least 14 in. (36 cm) of your 

speaker cable.
 

Allow enough cable for where you stand to connect 
the wires.

00_791_Speaker_IG.book  Page 7  Wednesday, April 15, 2009  8:33 AM