Инструкции По Установке для Electrolux EPWD15MB

CAUTION

EXCESSIVE WEIGHT HAZARD

To avoid back or other injury, have more than one person move
or lift the washer or dryer.

If washer or dryer is new and has not been installed yet, skip

to step 4.
If dryer is already installed, disconnect dryer from electrical

and gas connections and exhaust venting. On models with

Steam Option, turn off cold water supply and disconnect wa-

ter supply hose to dryer.
If washer is already installed, disconnect washer from electri-

cal connection. Turn off hot and cold water supply and dis-

connect hot and cold water supply hoses from water supply

outlets. Disconnect drain hose from drain pipe.
Protect floor with cardboard or other covering. Using two or

more persons, carefully tip the washer or dryer onto its back.

Take care not to damage hoses and/or electrical cords as you

lay the unit back.

A) Preparing washer or dryer for mount-

ing on pedestal

B) Preparing pedestal before mounting

washer or dryer

ENGLISH

Remove all four (4) adjustable leveling legs from the appliance

base and save for future use.

Locate pedestal to within a few inches of its final location.

NOTE

Allow for approximately 5 in. (12.5 cm) behind the pedestal
for clearance of back of washer or dryer to the wall. Allow an
additional 3/4 in. (2 cm) for water inlet on Steam Model Dryers
and additional space if venting dryer upward or downward.

NOTE

Due to higher center of gravity of appliance on pedestals,
some side-to-side rocking is normal during operation. Vibration
can be minimized by assuring appliance is installed properly,
including being level and solid on all four (4) legs by following
these directions.

NOTE

If leveling legs are not removed, mounting holes in appliance
will not align to mounting holes in brackets.

Level the pedestal front-to-back and side-to-side by adjusting

each leveling leg. Keep leg extension to a minimum.

raise

lower

Carefully return appliance to upright position.

DO NOT remove foam!