Руководство Пользователя для Maytag MHWE301YW

Promptly remove garments after cycle has 

completed to avoid odor and rusting of  

metal objects on garments. When unloading 

garments, pull back the door seal and check  

for small items between the tub and the basket.
If you will be unable to remove the load promptly, use  

the Fresh Spin

™

 option to automatically tumble the load  

periodically for up to 6 hours. 
NOTE:

n

 

After any wash cycle is completed, the door must be  

opened and then closed before a new cycle can begin.

n

 

A small amount of water may remain in the dispensers  

after the wash cycle is complete. This is normal.

n

This washer has a tight seal to avoid water leaks. To  

avoid odors, leave the door open to allow the washer  

to dry between uses. 

1.   Always use High Efficiency (HE) detergents and follow the 

HE detergent manufacturer’s instructions regarding the 

amount of HE detergent to use. Never use more than the 

recommended amount because that may increase the 

rate at which detergent and soil residue accumulate inside 

your washer, which in turn may result in undesirable odor.

2.    Use warm or hot water washes sometimes (not exclusively  

cold water washes), because they do a better job of  

controlling the rate at which soils and detergent accumulate.

3.    Always leave the washer door slightly ajar between uses 

to help dry out the washer and prevent the buildup of 

odor-causing residue.

Read these instructions completely before beginning the 

routine cleaning processes recommended below. This 

Washer Maintenance Procedure should be performed, 

at a minimum, once per month or every 30 wash cycles, 

whichever occurs sooner, to control the rate at which soils 

and detergent may otherwise accumulate in your washer.

Cleaning the Door Seal
1.   Open the washer door and remove any clothing or items 

from the washer.

2.   Inspect the seal between the door opening and the drum 

for stained areas or soil buildup. Pull back the seal to 

inspect all areas under the seal and to check for foreign 

objects.

3.   If stained areas or soil buildup are found, wipe down  

these areas of the seal using either of the following  

two procedures:

 

    i.   When the cycle is complete, gently pull back the 

rubber door seal and clean the entire surface with  

the rough side of the Grit Grabber™ cloth.

  b.  Dilute Liquid Chlorine Bleach Procedure:
    i.   Mix a dilute bleach solution, using 3/4 cup (177 mL) 

of liquid chlorine bleach and 1 gallon (3.8 L) of warm 

tap water.

    ii.  Wipe the seal area with the dilute solution, using  

a damp cloth.

    iii.  Let stand 5 minutes.
    iv.  Wipe down area thoroughly with a dry cloth and let 

washer interior air dry with door open.

 

  n Wear rubber gloves when cleaning with bleach.
  n  Refer to the bleach manufacturer’s instructions  

for proper use.