Инструкции Пользователя для Yamaha ysp-1600bl
PREPARATIONS
➤ a Installation
En
14
Mounting the unit on a wall
The unit can be mounted on a wall.
If the antenna will be used (p. 13), raise it before
mounting the unit on a wall.
mounting the unit on a wall.
• When installing the unit on a wall, all installation work must be
performed by a qualified contractor or dealer. The customer must
never attempt to perform this installation work. Improper or
inadequate installation could cause the unit to fall, resulting in
personal injury.
never attempt to perform this installation work. Improper or
inadequate installation could cause the unit to fall, resulting in
personal injury.
• To prevent the unit from falling, attach it to a wall constructed of
drywall (plasterboard).
• Make sure you use commercially available screws that can support
the weight of the installation (in step 2). Using clamps other than
specified screws, such as short screws, nails, and two-sided tape,
may cause the unit to fall.
specified screws, such as short screws, nails, and two-sided tape,
may cause the unit to fall.
• Fix the cables in place where they will not become loose. If your foot
or hand accidentally gets caught on a loose cable, the unit may fall.
• Check that the unit is fixed securely after the installation. Yamaha
will bear no responsibility for any accidents caused by improper
installations.
installations.
• Do not lean on the unit or apply excessive force to the top of the
unit. Doing so may cause the unit to fall.
1
Attach the mounting template on a wall
and mark for the screw holes.
and mark for the screw holes.
2
Remove the mounting template from the
wall and install the commercially available
screws at the marks on the wall.
wall and install the commercially available
screws at the marks on the wall.
3
Use the screws to attach the brackets
(both supplied).
(both supplied).
4
Hang the unit on the screws.
MOUNTING TEMPLATE/GABARIT DE FIXATION
DRILL HERE / PERCER CIC
ANTENNA / ANTENNE
457mm (18” )
457mm (18 po)
ZR85910-1
DRILL HERE / PERCER CIC
Tapes or
thumbtacks
Mounting template (supplied)
Screw
holes
holes
MOUNTING TEMPLATE/GABARIT DE FIXATION
DRILL HERE / PERCER CIC
ANTENNA / ANTENNE
457mm (18” )
457mm (18 po)
ZR85910-1
DRILL HERE / PERCER CIC
7 to 9 mm
(1/4" to 3/8")
2 to 4 mm
(1/16" to 3/16")
4 mm (#8)
20 mm (3/4") or more
Brackets
(supplied)
Position the
bracket so that
the protrusions
on the side of the
bracket fit into
the grooves on
the unit.
bracket so that
the protrusions
on the side of the
bracket fit into
the grooves on
the unit.
Screws
(supplied)
(supplied)
MOUNTING TEMPLATE/GABARIT DE FIXATION
DRILL HERE / PERCER CIC
ANTENNA / ANTENNE
457mm (18” )
457mm (18 po)
ZR85910-1
DRILL HERE / PERCER CIC
Bracket
mounting
holes
mounting
holes
1 2 3 4 5 6