Инструкции Пользователя для KitchenAid KXD4630YSS

Complete Preparation

1. Determine and make all necessary cuts for the vent system.

IMPORTANT: When cutting or drilling into the floor, ceiling or
wall, do not damage electrical wiring or other hidden utilities.

2. Determine the location where the

¹⁄₂" (1.3 cm) wiring conduit

will be routed through the floor, ceiling or wall between the in-
line blower and the downdraft vent.

3. Drill a 1

¹⁄₄" (3.2 cm) hole at this location.

4. Locate the electrical terminal boxes in the in-line blower

housing and downdraft vent. Remove the terminal box covers
and set the covers and screws aside.

5. Remove the electrical knockout from the in-line blower

housing and downdraft vent to prepare for the installation of
the UL listed or CSA approved

¹⁄₂" (1.3 cm) wiring conduit and

conduit connector.

6. With the downdraft vent mounted, run the

¹⁄₂" (1.3 cm) wiring

conduit between the in-line blower motor housing and the
downdraft vent. Pull enough

¹⁄₂" (1.3 cm) wiring conduit to

allow for easy connection to the terminal boxes in the in-line
blower housing and downdraft vent.

7. Run the six 18 AWG wires through the

¹⁄₂" (1.3 cm) wiring

conduit and conduit connectors and into the terminal boxes
on the in-line blower housing and downdraft vent. Leave
enough wire length in each terminal box to make the wiring
connections.

8. Install the conduit connectors and conduit to the in-line

blower housing and downdraft vent electrical terminal boxes.

9. Connect the vent system to the downdraft vent and in-line

blower system and seal all joints with clamps.

Make Electrical Connections for In-Line

Blower Motor System

Electrical Connection Inside In-line Blower System

1. Disconnect power.

2. Connect the wires from the wiring conduit to the wires from

the motor electrical plug cable inside the in-line blower
housing terminal box.

3. Use UL listed wire connectors and connect the black wires

4. Use UL listed wire connectors and connect the white wires

(D) together.

5. Use UL listed wire connectors and connect the red wires (E)

together.

6. Use UL listed wire connectors and connect the blue wires (F)

together.

7. Use UL listed wire connectors and connect the gray wires (G)

together.

A. Electrical terminal box
B. Electrical knockout

A. UL listed or CSA approved

¹⁄₂

" (1.3 cm) wiring conduit

B. UL listed wire connectors

C. Black wires
D. White wires

E. Red wires

F. Blue wires

G. Gray wires

H. Green (or yellow/green)

and green/yellow wires

I. Motor electrical plug cable

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.