Справочник Пользователя для Philips SPD8020CC/10
31
Maintenance
Firmware update
CAUTION
1. Never turn off your NAS during the firmware update procedure. This may damage your device. If for
any reason (E.g. Power supply failure during firmware update) the procedure fails, you may not be
able to operate your device.
able to operate your device.
2. Always use Philips firmware.
Option 1 – Automatic firmware download
The Philips Intelligent Agent searches automatically
the correct update for your drive in only a few simple
steps
steps
1. Visit the Philips Intelligent Agent website at
www.storageupdates.philips.com/en/pia.html
2. Read the instructions mentioned on the page,
on how to install and run the Philips Intelligent
Agent
3. Proceed at ‘Firmware update’ below
The Philips Intelligent Agent can also be found on your
installation CD
Option 2 – Manual firmware download
1. Visit the Philips support website at
www.philips.com/storageupdates
2. Go to the section of the NAS
3. Download the latest firmware (zipfile) to your
PC
4. Proceed at ‘Firmware update’ below
Firmware update
1. Extract the firmware image file from the zipfile
2. Connect your NAS to your network
3. Switch on the NAS
4. Use the ‘Manage’ button in the Philips
network storage wizard to open the NAS
administration console
Or use the ‘Manage’ shortcut on your desktop
If no shortcut was created during installation, run
the installation wizard as mentioned in the
chapter ‘How to install your NAS’, and make
sure that you select the first and second option
sure that you select the first and second option