Справочник Пользователя для DELL C4130

Installing a 1.8 inch uSATA SSD blank

Install the SSD blank if you are removing the SSD permanently or not replacing it immediately.
Prerequisites
Ensure that you read the 

Steps

Insert the SSD blank into the SSD slot until the release button clicks into place.

Removing a 1.8 inch uSATA SSD carrier

You need to remove the SSD carrier because the SSD is installed in the SSD carrier.
Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only 

perform troubleshooting and simple repairs as authorized in your product documentation, or as 

directed by the online or telephone service and support team. Damage due to servicing that is 

not authorized by Dell is not covered by your warranty. Read and follow the safety instructions 

that came with the product.

1.

2.

Using the management software, prepare the SSD for removal. Wait until the indicators on the SSD 

carrier signal that the SSD can be removed safely.
If the SSD is online, the green activity/fault indicator flashes as the drive is turned off. When the SSD 
indicators are off, the SSD drive is ready for removal. For more information, see the documentation 
for the storage controller.

NOTE: The 1.8 inch uSATA SSDs are hot swappable only with software RAID S130. If your 

system supports software RAID S130 proceed to step 4. If not, continue with step 3.

3.

Turn off the system, including any attached peripherals.

4.

Disconnect the system from the electrical outlet and disconnect the peripherals.

Steps
1.

Press the release button to open the SSD carrier release handle.

2. Slide the SSD carrier out of the SSD cage.

The SSD is installed in the SSD carrier.

CAUTION: To maintain proper system cooling, all empty SSD slots must have SSD blanks 
installed.

100