Справочник Пользователя для DELL C4130

2.

3.

If applicable, install the expansion card(s) into the expansion card riser. For more information, see 

Steps
1.

Align the expansion card riser with the guide pin on the system board and the guide slot on the 
chassis.

2. Lower the expansion card riser and press it until it clicks into place.

CAUTION: The expansion card riser should be installed in the system before you install the 
expansion card riser cables to prevent pin damage in the PCIe connectors on the system 
board.

Next steps

1.

If applicable, connect the riser cables to the system board.

2.

Install the PCIe shroud.

3.

. 

4.

Install any device drivers required for the expansion card. For more information, see the 

documentation for the card.

Related Tasks

Removing expansion cards

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only 

perform troubleshooting and simple repairs as authorized in your product documentation, or as 

directed by the online or telephone service and support team. Damage due to servicing that is 

not authorized by Dell is not covered by your warranty. Read and follow the safety instructions 

that came with the product.

1.

2.

3.

Disconnect any cables connected to the expansion card and the system board.

CAUTION: The expansion card riser cables should be removed before removing the 

expansion card riser to prevent pin damage in the PCIe connectors on the system/switch 

board.

4.

Remove the PCIe shroud. For more information, see 

.

5.

Steps
1.

Pull the expansion card latch to open it.

2. Open the expansion card clip.
3. Hold the expansion card by its edges, and remove it from the expansion card connector.
4. If you are removing the expansion card permanently, install an expansion card blank by performing 

the following steps:
a. Slide the expansion card blank into the expansion card slot on the side of the expansion card 

riser.

80