Справочник Пользователя для Nortel Networks 400 4.0
254
Chapter 22 Replacing the hard disk
N0060612
N0060612
provides an overview of the hard disk replacement process.
Figure 122 Hard disk replacement overview
Note: Maintain a current backup of your system
When you replace the hard disk, you need to restore the BCM system programming from
the backup using the backup and restore utility (BRU). If you do not have a current
backup, you must reenter configuration data. For further information on how to perform a
backup or restore, refer to the BCM 4.0 Administration Guide.
the backup using the backup and restore utility (BRU). If you do not have a current
backup, you must reenter configuration data. For further information on how to perform a
backup or restore, refer to the BCM 4.0 Administration Guide.
Caution: Do not use an electric or magnetized screwdriver near the hard disk. You can
lose the information stored on the disk. Shock can damage the hard disk. Do not drop or
hit the hard disk drive.
Warning: You must remove all of the connections to the BCM main unit base function
tray before you power the system down. Failure to disconnect lines before power down
can cause damage to the system.
tray before you power the system down. Failure to disconnect lines before power down
can cause damage to the system.
Warning: Protect the hardware components against damage from electrostatic discharge.
Always wear a grounded wriststrap before you handle components. Always place the
components in a static-free container.
Always wear a grounded wriststrap before you handle components. Always place the
components in a static-free container.
If possible, do
a software
shutdown
a software
shutdown
Set up unit for
maintenance
maintenance
Remove the hard
disk and replace
with new disk
disk and replace
with new disk
Restore unit to
operation
operation
Test all functions
Perform system
initialization and a
BRU data restore
initialization and a
BRU data restore