Справочник Пользователя для Pelco SD4N-B0-X
22
C3446M (7/08)
Reset Button
Use the reset button located underneath the trim ring on the mounting flange to access the following
modes:
modes:
To access one of these modes:
1. Press and hold the reset button. The unit starts cycling through the modes; hold the button for four
seconds to access (cycle through) each mode. The unit status indicator LED flashes the color for the
current mode (refer to the table above).
current mode (refer to the table above).
2. When the color of the desired mode appears, release the button.
NOTES:
•
If there is no configuration activity for 15 minutes, the dome system will automatically exit the reset
mode.
mode.
•
The LED is not lit during normal operation.
Figure 19. Location of Reset Button and LED
Mode
Function
Unit Status Indicator Light
Configuration
Starts the reset LED
selection sequence.
selection sequence.
Flashes green.
Reboot
Restarts the unit.
Flashes green and red simultaneously when entering this
mode. The LED then flashes green when mode is selected
and during the reboot.
mode. The LED then flashes green when mode is selected
and during the reboot.
Reset
Resets unit to factory
default settings and
then restarts unit.
default settings and
then restarts unit.
Flashes red when entering this mode. Flashes red when
mode is selected, and then flashes green when dome
system restarts. Dome system is off line during reset
mode.
mode is selected, and then flashes green when dome
system restarts. Dome system is off line during reset
mode.
Cancel Cancels
any
configuration or reset
action.
action.
No light.
Status Indicator LED
Reset Button