Справочник Пользователя для Mitsubishi Electronics MUZ-FD09NA

32

 : Turn OFF power supply before disassembling.

(1) Remove the screw fixing the service panel. (See 

Photo 1.)

(2) Pull down the service panel and remove it. (See Photo 

1.)

(3) Remove the screws fixing the conduit cover. (See 

Photo 2.)

(4) Remove the conduit cover. (See Photo 2.)
(5) Disconnect the power supply wire and indoor/outdoor 

connecting wire.

(6) Remove the screws fixing the top panel. (See Photo 1.)
(7) Remove the top panel. (See Photo 1.)
(8) Remove the screws fixing the cabinet.
(9) Remove the cabinet.
(10) Remove the screws fixing the back panel.
(11) Remove the back panel.

Screws of 
the cabinet

Back 
panel

Service 

panel

Screws of 
the top panel

Screw of the 
cabinet

Screws 
of the top 
panel

Hooks

Screw of the 

conduit cover

Conduit plate

Screw of 

the service 

panel

Conduit cover

32

(1)  Slide the sleeve and check if there is a locking lever or not.

(2)  The terminal with this connector has the 
      locking mechanism.

Slide the sleeve.
Pull the terminal while 
pushing the locking
lever.

Hold the sleeve, and 
pull out the terminal 
slowly.

<"Terminal with locking mechanism" Detaching points>

The terminal which has the locking mechanism can be detached as shown below.
There are two types (refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.