Справочник Пользователя для 3D Connexion 466-1513-01

The purpose of this weekly test is to verify that the panel is activating sirens with the appropriate 
warning sounds.

1. Contact the central monitoring station to inform them that you will be activating alarms and 

they should not dispatch authorities.

2. Activate alarms of each type (fire, police, auxiliary), one at a time.

3. Listen for the appropriate siren sound when each alarm is activated (see the “Alarm Sounds 

and Status Beeps” table on page 49).

4. Contact the central monitoring station to inform them that you are finished activating alarms.

Your security system uses a variety of different alarm sirens, status beeps, voice messages and 
trouble beeps to communicate with you. The next few pages describe the different sounds and 
what they mean. Try to familiarize yourself with the differences. You will hear sounds each time 
you tell your security system to do something, like arm or disarm. Some sounds you will hear 
only when there is a problem with the system, like a low battery. There are also sounds you will 
only hear in an emergency. Getting to know your system sounds allows you to react quickly and 
appropriately to the messages you hear.

When your system detects a problem, it lets you know by sounding trouble beeps from system 
touchpads and sirens, and by displaying trouble signals as messages on touchpads.

Trouble beeps are a series of five short beeps once a minute.

The table on the next page lists the causes of trouble beeps, the visual display you can expect to 
see, and possible solutions for the trouble condition.

If possible, correct the situation which is causing the trouble beeps. If this is not possible, call for 
service. If the problem is not corrected, trouble beeps and messages start again 4 or 10 hours 
later.

Your security system also has a feature that will prevent trouble beeps from starting during nor-
mal sleeping hours. This “sleep time” period is normally set from 10 pm to 8 am. Contact your 
installer if you wish to verify or change this setting.

1. Perform a system status check by pressing 

*

 on a touchpad,

2. Change the arming level.

The table on the next page describes the conditions under which trouble beeps occur and when 
they begin. (These sounds are heard from interior sirens and touchpads if available.)

A.Try the following:

•

If arming to Level 2—STAY or Level 3—AWAY, make sure all monitored perimeter doors 
and windows are closed.

•

Press 

*

 for a system status and for clues to the problem.

•

Call the installer.

A.Possible explanations include:

•

The sensor you’re trying to bypass may not be active in the current arming level. For exam-
ple, an interior motion detector will not be active in Level 2—STAY.

•

You may be trying to bypass a 24-hour sensor that cannot be bypassed, such as a smoke 
detector.