Справочник Пользователя для Invacare Adjustable ASBA Seat

SECTION 6—FRONT RIGGINGS

CAUTION

Make sure coved spacers are positioned properly when reassembling to prevent
damage to the frame mounting tubes.

6. Reinstall the footrest(s) onto the wheelchair. Refer to Installing/Removing Footrests on

7. Reinstall any accessory onto the footrest(s).

Replacing Heel Loops

NOTE: For this procedure, refer to FIGURE 6.6.

1. Note the position of hex bolt, coved washers and locknut for reinstallation.

2. Remove the hex bolt, coved washers and locknut that secure the lower footrest to the

footrest support.

3. Remove the lower footrest.

4. Remove the phillips bolt, spacer and

locknut that secure the heel loop to the
lower footrest.

5. Slide the heel loop off the lower

footrest.

6. Replace heel loop.

7. Reverse STEPS 1‐6 to reassemble.

NOTE: When securing heel loop to lower
footrest, tighten the phillips bolt and locknut
until the spacer is secure.

FIGURE 6.6 Replacing Heel Loops

Raising/Lowering Elevating Front Riggings

NOTE: For this procedure, refer to FIGURE 6.7.

1. Perform one of the following:

• Raising ‐ Pull back on the release

lever and raise front rigging to the
desired height.

• Lowering ‐ Support front rigging

with one hand away from the
release lever. Push release lever
downward with other hand.

FIGURE 6.7 Raising/Lowering Elevating

Footrest Support

Hex Bolt

Phillips Bolt

Spacer

Heel

Loop

Locknut

Lower Footrest

Coved

Washer

Locknut

Release

Lever