Справочник Пользователя для Invacare Adjustable ASBA Seat

SECTION 7—POWER ELEVATING LEGRESTS

6. If necessary, adjust powered legs. Refer to Adjusting the Power Elevating Legrests

below.

Removing the Power Elevating Legrests

1. Disconnect power legrests from the harness.

2. Push powered legrest release handle toward the opposite side of the wheelchair and

swing legrest to the outside of the wheelchair.

3. Lift powered legrest and remove from wheelchair.

4. Repeat STEPS 1‐3 for opposite power legrest.

FIGURE 7.1 Installing/Removing the Power Elevating Legrests

Adjusting the Power Elevating Legrests

Adjusting the Footplate

WARNING

DO NOT remove heel loops without providing some other adequate means of
support. Otherwise personal injury may occur.

Adjusting the Footplate Height

NOTE: For this procedure, refer to FIGURE 7.2 on page 36.

NOTE: The following procedure should be performed with the user in the wheelchair.

NOTE: T‐nuts ride in the channels of the exterior/interior rails of the power legrests. Refer to
FIGURE 7.2.

1. Loosen, but DO NOT remove, the two interior button screws that secure the footplate

assembly to the T‐nuts.

Calf Pad

Footplate

Legrest Release

Handle

Mounting

Hole

DETAIL “A”

DETAIL “B”

Jumper

Cable

Power

Legrest

Connector

Mounting Pin