Справочник Пользователя для Mitsubishi Electronics C64T

 
 

280 

(SETUP PARAM 6. 5/6) to (SETUP PARAM 6. 6/6) 

6401 
6402 

 
 
 
 
 
 
 
 

6495 
6496 

R4600-Low 
R4600-High 
 
 
 
 
 
 
 
 
R4647-Low 
R4647-High 

Bit selection 

This is the bit type parameter used in the 
PLC program (ladder). 
Even if the data is set in the R register 
that corresponds to the PLC side when 
this parameter is displayed‚ the screen 
will not change.  Enter a different screen 
once‚ and then select this screen again. 
 
Note that some parameters have limited 
uses. 

0: OFF 
1: ON 

6413 

 

bit0 
Dual monitoring 
interruption 

Reserved for the system. 
Used for only C64T. 

0/1 
Standard: 0 

bit6 
Communication 
terminal overheat 
detected 

Designate whether to detect the 
communication terminal overheat alarm 
or not. 
  0: Detects the overheat alarm. 
  1:  Does not detect the overheat alarm.

 

0: Detect 
1: Not detect 

6449 

 

bit7 
Control unit 
overheat detected

Designate whether to detect the control 
unit overheat alarm or not. 
  0: Detects the overheat alarm. 
  1:  Does not detect the overheat alarm.

 

0: Detect 
1: Not detect 

6454 

 

 

bit0 
Macro interface 
for respective part 
systems 

Designate whether to use the macro 
interface for respective part systems or 
not. 

0: Conventional macro interface 

common to part systems. 

1: Available to respective part systems. 

0/1 

6457 

 

 

bit0,1 
High-speed input 
specification 

bit0: High-speed input from R54. 
bit1: High-speed input from R55. 
 
Note that this is used for only C64T. 

bit0: 0/1 
bit1: 0/1 

6458 

 

 

bit0,1 
High-speed 
output 
specification 

bit0: High-speed output to R56 
bit1: High-speed output to R57 
 
Note that this is used for only C64T. 

bit0: 0/1 
bit1: 0/1 

 

 

  When setting the parameter (#6449/bit6,7) not to check the overheat, the control unit and 

the communication terminal may not be controlled because of overheat. 

In such case, axis runaway may cause a machine breakage, an accident resulting in injury 

or death, or device breakage. 

To prevent the serious results, ordinarily set the parameters so that the overheat check is 

valid.