Справочник Пользователя для Mitsubishi Electronics EW230U-ST

EN-13

1.

Determine the aspect ratio of your screen, 16:10 or 16:9. If you have a 16:10 screen, refer to the table labeled 

. If you have a 16:9 screen, refer to the table labeled 

.

2.

Select your screen size.

3.

Refer to the table and find the closest match to your screen size in the left columns labeled 

. Using this 

value, look across this row to the right to find the corresponding average distance from screen value in the 
column labeled 

. This is the projection distance.

4.

On that same row, look across to the right column and make note of the 

 value. This will determine the final 

vertical offset placement of the projector in relation to the edge of the screen.

5.

The recommended position for the projector is aligned perpendicular to the horizontal center of the screen, at the 
distance from the screen determined in step 3 above, and offset by the value determined in step 4 above.

For example, if you are using a 16:10 aspect ratio, 100-inch screen, distance from the screen is 1.1 m and with a 

vertical offset of 7 cm.

If you place the projector in a different position (to that recommended), you will have to tilt it down or up to center the 

image on the screen. In these situations, some image distortion will occur. Use the Keystone function to correct the 

 for details.

This method can be used for situations where you have purchased this projector and would like to know what screen 

size will fit in your room.

The maximum screen size is limited by the physical space available in your room. 

1.

Measure the distance between the projector and where you want to position the screen. This is the projection 
distance.

2.

Refer to the table 

 or 

, and find the closest match to your measurement in the distance from 

the screen column. If the min and max values are available on the table, check that your measured distance is 
between the min and max distances listed on either side of the average distance value.

3.

Using this value, look across that row to the left to find the corresponding 

. That is the projected image 

size of the projector at that projection distance.

4.

On that same row, look across to the right column and make note of the 

 value. This will determine the final 

placement of the screen in relation to the horizontal plane of the projector. 

For example, if your measured projection distance was 1.5 m and your screen aspect ratio is 16:10, the closest match 

in the 

 column is from 1.6 m. Looking across this row shows that a 150-inch screen is 

required.