Справочник Пользователя для Q-Logic 2400
5–Fibre Channel Noninteractive Commands
Command Summary
SN0054667-00 C
5-5
Command Summary
This section lists and describes each command line option in alphabetic order,
followed by a command description.
followed by a command description.
-a
(View or Toggle Beacon Status)
Use the -a command to either view (1) or change (2) the status of a beacon.
To view the adapter port’s LED beacon state, issue the following command:
# qaucli -pr fc -a (<hba instance> | <hba wwpn>)(view | info)
When the adapter’s LED is flashing, the following message appears:
HBA Port x - LED Flashing is ON.
When the adapter’s LED is not flashing, the following message appears:
HBA Port x - LED Flashing is OFF.
To start or stop flashing the adapter’s LED beacon, issue the following command:
# qaucli -pr fc -a (<hba instance> | <hba wwpn>)
QConvergeConsole CLI toggles the LED’s state. If the LED is flashing, the
flashing stops. If the LED is not flashing, the flashing begins.
flashing stops. If the LED is not flashing, the flashing begins.
<target id>
Target ID
<lun id>
Logical unit number
(0–255)
<address>
IP address
xxx.xxx.xxx.xxx
(speed)
Target link speed
1.2, 4, or 8GHz
a
You can use the -g command to find adapter numbers.
b
You assign the symbolic name. It is limited to 100 characters in length.
NOTE:
Adapter must not be in silent mode. See
to issue a response to this command.
The -a feature is not supported on QLA22xx adapters or QLE8042
adapter.
Table 5-2. Command Variables (Continued)
Variable
Definition
Format