Справочник Пользователя для Mitsubishi Electronics QD75P1
11 - 30
MELSEC-Q
11 MANUAL CONTROL
11.4.2 Manual pulse generator operation execution procedure
The manual pulse generator operation is carried out by the following procedure.
<Method 1>
Directly set (write) the parameters in the QD75 using
Directly set (write) the parameters in the QD75 using
<Method 2>
STEP 1
Manual pulse
generator operation
start
generator operation
start
End of control
STEP 2
STEP 3
Write the sequence program created in STEP 1 and
STEP 2 to the CPU module using GX Developer.
STEP 2 to the CPU module using GX Developer.
Issue a command to enable the manual pulse generator
operation, and input the signals from the manual pulse
operation, and input the signals from the manual pulse
End the input from the manual pulse generator,
and issue a command to disable the manual pulse
and issue a command to disable the manual pulse
Manual pulse
generator operation
stop
generator operation
stop
Monitor the manual pulse generator operation.
Preparation
Refer to
CHAPTER 5 and
Section 11.4.3.
CHAPTER 5 and
Section 11.4.3.
Refer to Section
11.4.4.
11.4.4.
Set the parameters
Write the sequence program to the CPU
module.
module.
One of the following two methods can be used.
<Method 1>
Monitor using GX Configurator-QP.
<Method 2>
Monitor using GX Configurator-QP.
<Method 2>
Monitoring of the
manual pulse
generator operation
manual pulse
generator operation
Set " Cd. 20 Manual pulse generator 1 pulse input
to
)
Pr.1
)
Pr.24
Create a sequence program in which the enable/disable is
(" Cd. 21 Manual pulse generator enable flag" setting.)
STEP 4
STEP 5
STEP 6
magnification". (control data setting)
set for the manual pulse generator operation.
generator.
One of the following two methods can be used.
GX Configurator-QP.
Using GX Developer, set the control data and create a
sequence program to enable/disable the manual pulse
generator operation. (Set the control data in the QD75
buffer memory using the TO instruction.)
sequence program to enable/disable the manual pulse
generator operation. (Set the control data in the QD75
buffer memory using the TO instruction.)
Write "1" in " Cd.21 Manual pulse generator enable
flag", and operate the manual pulse generator.
flag", and operate the manual pulse generator.
Monitor using GX Developer.
Stop operating the manual pulse generator, and write "0"
in " Cd. 21 Manual pulse generator enable flag".
in " Cd. 21 Manual pulse generator enable flag".
Set (write) the parameters from the CPU module to the
QD75 using the sequence program (TO instruction).
QD75 using the sequence program (TO instruction).
REMARK
Mechanical elements such as limit switches are considered as already installed.
Parameter settings work in common for all control using the QD75.