Справочник Пользователя для Mitsubishi Electronics QD75P1N

 
 

 

Appendix - 71 

MELSEC-Q

APPENDICES 

 

Appendix 10 When using GX Works2 

The following shows the procedure for positioning operation when GX Works2 is used. 

 

(          GX Works2 Version1 Operating Manual (Common))

(          GX Works2 Version1 Operating Manual (Common))

(          Appendix 10.1 Adding a module)

(

Appendix 10.2 Setting parameters, 

           

 

Appendix 10.3 Setting auto refresh)

(          CHAPTER 6 SEQUENCE PROGRAM USED FOR POSITIONING CONTROL)

Start

Starting operation

End

Configure parameters 

and positioning data with 

GX Works2?

YES

NO

Starting GX Works2

   Start GX Works2.

Creating a new project

   Create a new project.

Adding a module

   Add a module for the project.

Setting parameters and auto refresh

   Configure each setting with GX Works2.

Programming and debugging

   Create and debug a program.

Creating programs for parameters and data

   Create programs to set parameters and data.

Writing data to flash ROM

   Write data to the flash ROM.

Testing and tracing

  Test operation and trace waveform and

  location of positioning.

Monitoring

  Monitor the operating status of the QD75.

(          Appendix 10.9 Execution data backup function)

(

Appendix 10.4 Positioning monitor)

(

Appendix 10.5 Positioning test,

           

 

Appendix 10.6 Wave trace,

           

 

Appendix 10.7 Location trace)

(         

 

CHAPTER 6 SEQUENCE

           PROGRAM USED FOR
           POSITIONING CONTROL)

 

 

For details on the operation method of GX Works2, refer to the following. 
GX Works2 Version 1 Operating Manual (Common) 
For details on operation in GX Works2 for the QD75, refer to the following. 
GX Works2 Version 1 Operating Manual (Intelligent Function Module)