Справочник Пользователя для 3com WX1200 3CRWX120695A

The profile uses the default radio profile by default. You can change the 
profile using the set ap auto radio radio-profile command. You can 
use set ap auto commands to change settings for the parameters listed 
in Table 71. (The commands are listed in the “See Also” section.)

Examples — The following command creates a profile for automatic 
Distributed MAP configuration:

WX1200# set ap auto

success: change accepted.

„

„

„

„

Table 71   Configurable Profile Parameters for Distributed MAPs

(Not shown in display ap config 
output)

disable (NO)

group (load balancing group)

upgrade-firmware
(boot-download-enabled)

enable (YES)

radio num auto-tune
max-power

radio num mode

radio num radio-profile

(or 11b for country codes where 
802.11g is not allowed)