Листовка для GE Monogram ZGG540LBPSS
For answers to your Monogram,
®
GE Profile
™
or
GE
®
appliance questions, visit our website at
ge.com or call GE Answer Center
®
service,
800.626.2000.
170134
Specification Created 10/08
ZGG540NBPSS - Natural Gas Built-in Outdoor Grill
ZGG540LBPSS - LP Gas Built-in Outdoor Grill
Dimensions and Installation Information (in inches)
Outdoor Built-in Cooktop
These grills are designed to be installed into a non-
combustible enclousure.
• The grill drops into the opening and hangs from
combustible enclousure.
• The grill drops into the opening and hangs from
the side flanges. It does not require support from
the bottom.
the bottom.
• The cutout must be completely covered with
non-combustible material such as stone, brick,
ceramic tile, concrete board, etc. The countertop
surface and edges must be flat and level.
ceramic tile, concrete board, etc. The countertop
surface and edges must be flat and level.
• If the countertop has an overhang, it must be
notched or cut back flush with the front face of
the cabinet below. See notched detail below.
the cabinet below. See notched detail below.
• Allow at least 12" minimum clearance at the
back of the grill when the exhaust is directed to a
window or surface that is difficult to clean. Allow
at least 4" clearance behind the grill to allow the
hood lid to open.
window or surface that is difficult to clean. Allow
at least 4" clearance behind the grill to allow the
hood lid to open.
• Allow 12" minimum clearance on both sides
and the back of the grill to adjacent vertical
combustible construction.
combustible construction.
• These gas grills cannot be used below any type of
overhead construction.
• These grills are designed for outdoor use only. Do
not locate the cooktop in a building, garage or
other enclosed or semi-enclosed area.
other enclosed or semi-enclosed area.
• Locate the backside of the grill away from
prevailing winds and avoid cooking in windy
conditions.
conditions.
53-7/8"
27"
12" Min. to Combustibles
4" Min. Clearance for Lid
to Non-Combustibles
26"
*The weight of the grill is fully supported by
the side trims. The back of the grill overlaps
the back edge of the cutout.
10-1/4" from
Bottom of
Support Flange
*25-1/2"
Countertop Depth
27" to Front
of Control Panel
28-1/2" to Front of Bullnose
52-3/4"
36"
Min.
1-1/8" Min.
10-7/8"
24-1/2"
Grill Cutout
Gas and
Electrical
Locations
Opening
for Optional
Access Doors